Secure your car-mounting system or accessories onto a vehicle, glass, or surface using the NATO Mounting Bracket from Tilta. The mounting bracket is designed with a NATO rail that supports a variety of NATO accessories, and it mounts onto a separately available Tilta 4.5" electronic suction cup using four M4 screws. One 3/8"-16 and two 1/4"-20  anti-twist threads along the rail accommodate even more accessory types.

Bracket with NATO Rail on Top    Mounts onto 4.5" Electronic Suction Cup    1/4"-20 and 3/8"-16 Anti-Twist Threads    Mounts Using Four Screws    Durable Aluminum Construction

Related Questions and Answers

Q: 1. Will this work with the DJI Ronin m?

A: Yes, you will need to use an adapter for the Ronin M.

Q: 2. What kind of adapter is needed for this to work with the DJI Ronin m?

A: The Tilta Hydra Alien Car Mounting System (V-Mount) is compatible with any gimbal that can mount via 1/4″-20 screws and power via P-Tap.

Q: 3. Is a gimbal required

A: The Tilta Hydra Alien Car Mounting System (V-Mount) is just a mounting solution. It does not include a gimbal with the kit. This system is compatible with the DJI RS2, RS3, RS3 Pro, RS4 Pro, Crane 3S, Ronin 4D and any other gimbal that can mount via 1/4″-20 screws and power via D-Tap or internally.

Q: 4. Does this work with the DJI RS3 Pro?

A: Yes, the Tilta Hydra Alien Car Mounting System is compatible with the DJI RS3 Pro,.

Q: 5. Bag?

A: Yes, a Waterproof Hard-Shell Safety Case is included.

Q: 6. Where can you get replacement plates for the mount? Can't find them.

A: You will have to get replacement plates for the Tilta Hydra Alien Car Mounting System (V-Mount) directly through Tilta.

Q: 7. What is the load capacity?

A: The payload for the Hydra Alien is roughly 15 to 18 pounds.

Q: 8. does the design of this rig make it difficult to mount the gimbal low to the ground? for example: with 1 cup connected low to the bumper and 2 cups connected to the flat/gently-curved part of the trunk/hood, it looks to me like the diagonally-mounted support strut might be easily blocked by the edge of the hood/trunk when trying to connect it from the vertical to the horizontal piece ~ does this make sense? thoughts?

A: There are a number of different ways to mount this support depending on the accessories that you would like to purchase with it and where you want to position it on the car. for example to get low angle shots it seems imperative that you purchase some single handed gimbal ( like the Ronin RS2). On the sides of the car it would be quite easy to get a low angle shot when mounted to the car door on the front or back of the car it seems as though it would be quite difficult. The design of the car will also affect how easy/difficult it is to get the shots that you want. for example in the photos they used a BMW Sedan which poses a challenge when mounting this rig to the rear but if they were to swap that car for an SUV, or mini van then there would be a lot more surface area on the back of the car making it feasible to get a low angle shot from the back.

Q: 9. How long is the arm?

A: The arm is 258mm long.

Q: 10. Will this work with the Ronin S if I were to get the Tilta wireless control kit for the ronin S?

A: Yes it will.