This pack of Long Shaft 1/4"-20 Cap Screws from Desmond consists of ten stainless steel screws with 0.5" shafts. The screws have both a slot and a hex socket, and are made for quick-release plates.

Stainless Steel    Slot and Hex Socket    For QR Plates

Related Questions and Answers

Q: 1. Does this screw work with the Sachtler Camera plate 16?

A: This may work for your needs, but the Sachtler SKO12E0353 3/8 -16 Screw for Select Sachtler Tripod Plates is specifically designed for your plate: https://bhpho.to/2r2csnO

Q: 2. This item does not have the same dimensions as a real Sachtler screw (I just measured one.) Sachtler plates are notorious for needing an exact screw to hold a camera tightly. Why is this being advertised as a screw for Sachtler tripods? Can you independently verify this works with Sachtler tripods?

A: The Desmond Knurled 1/4 -20 Slotted Screws have the same measurement as Satchler QR Screws, with a length of 15mm.

Q: 3. Will this 3/8-16 screw work with a Sachtler SAWPDV1 Sideload Plate?

A: The Desmond Knurled 3/8"-16 Slotted Screws (3-Pack) should work with the Sachtler Sideload Plate S/Ace Tripod QR Plate.

Q: 4. Will this fit a manfrotto fluid head that's 2 inches wide?

A: The Desmond Long Quick Release Plate (250mm) is an Arca-Type compatible plate. If your Manfrotto fluid head is Arca-Type compatible it will fit.

Q: 5. I was wondering what the outer diameter of the black knob is - I'm looking to design a rig and I want to make sure I don't run into a conflict! Thank you.

A: The outer diameter of the black knob is 1.16 .

Q: 6. Do these screws work with the Really Right Stuff One-piece L-bracket for the Nikon Z 7?

A: Yes, the Really Right Stuff One-piece L Bracket for the Nikon Z uses standard 1/4-20 sockets, so these screws should work just fine.

Q: 7. Do these items screw into each other snugly, or is the 11mm length of the screw too long, and it leaves a gap?

A: Yes, theses Vello 1/4"-20 Camera Screw Kit (6 Screws Total) are supposed to fit snug not leave any gaps.

Q: 8. I ordered this and it was not the Right screw for me what is the right one where I can slide it down a mounting bar after threading it in? Something longer.

A: A shoulder screw seems the appropriate fastener if I understand the situation. These have a threaded portion at the end of the shaft and an unthreaded portion beneath the head. The shoulder is formed at the border between the two portions, the unthreaded area being of greater diameter than the threaded. This shoulder allows the screw to be secured in the camera before it bottoms out in the hole. Please try a search for 'shoulder screws' to understand the variety of configurations or visit a good hardware store. The standard 1/4-20 threading applies.

Q: 9. Is there anything that can mount in the front of the handle if you remove the plug?

A: The SmallRig Top Handle with Rubber Grip has 1/4 20 screw connections and a shoe mount on the front of the handle that would allow you to mount gear.

Q: 10. Does this screw work with the Sachtler Camera Plate 16?

A: It will fit the Sachtler plate. Be sure however, it is not too long for the plate and your camera. Too long and too tight and the screw will damage your camera.