The Quick Latch Flex Clamp from IndePRO Tools can effortlessly secure light ballasts or other power supply devices onto C-stands or light poles. The integrated nylon web strap can be customized to perfectly fit any device. This clamp can securely hold devices up to 20 lb, offering reliable support for creative lighting endeavors.

Load Capacity: 20 lb    Nylon Web Strap    Jaw Clamp with Rubberized Pads    Large, Ergonomic Locking Knob

Related Questions and Answers

Q: 1. If you place two IDX 14.5 V batteries into the case will the 4 pin output 14V or 28 V?

A: When using the IndiPRO Tools Field Power Station the voltage output would match the batteries you work with. 14.8v batteries would output 14.8v and 26v would output 26v. The voltage would match the batteries you supply. Both the 4pin and 3pin connector would output the same voltage as the batteries supplied.

Q: 2. What is the charging time on a dead battery?

A: It all depends on the type of charger that you are using to charge the battery. For example if you were to use a 2.5A charger the battery would be fully charged in approximately 3 hours.

Q: 3. can this be used on the 190 series or other manfrotto tripods with the easy link?

A: Perfectly. In the body ( not the head) there is a female hole to screw in the male end of it

Q: 4. Can I charge this battery by using the d-tap connector?

A: Yes, although I assume that may be contingent on the D-Tap charger you're using. I'm not aware of any compatibility issues, but let's say that I'm 99% sure your D-Tap charger will be fine. I know mine was...although, as you you know, charging these batteries via D-Tap is SLOW.

Q: 5. How hard is it to bend?

A: It is easy to bend

Q: 6. Is the case big enough to fit two 270wh Shape Full Play (4.72 x 3.58 x 3.54 in) batteries?

A: Yep, the IndiPRO Tools Field Power Station (V-Mount) is compatible with those batteries.

Q: 7. Can you power stuff through the v-mount? Or just the dc output.

A: There are 2 different ways to power with this unit. You can power directly from the V-Mount connection from the back of the plate or through the 2.5mm output jack that is located on the side. You will just need the 2.5mm connector cable to power your specific device/camera.

Q: 8. Is this charger compatible with Core SWX HyperCore batteries?

A: Yes, will work with any batter with a unregulated D-tap output

Q: 9. how much weight can this hold?

A: Not too much. We use it as a go pro flexible mount. I would suggest not to put more weight than an action cam

Q: 10. Is this charger commatible with iDX duo batteries?

A: Yes, this charger is compatible with the IDX duo batteries. All you need to do is plug the charger into the d-tap port of the battery and it will charge.