Use wide-angle lenses with the Intrepid 4 x 5 view camera with this Recessed Lens Board. The board brings the lens 13mm closer to the focal plane, allowing for the use of lenses between 75 and 90mm. Designed for any lens with a Copal 0 or Compur 0 shutter, the board also comes with an extension pin to use with standard shutter-release cables. The lens board was made for the Intrepid 4x5 View Camera but will also work with any camera that accepts Linhof-style boards.

For Wide-Angle Lenses on 4 x 5 Camera    Compatible with Copal/Compur 0 Shutters    Extension Pin for Shutter Release Cable

Related Questions and Answers

Q: 1. Does this interface enable the recording from the SDI input directly to the SxS card (no XDCAM disc)?Thanks

A: This updates the older version of the PDW-HR1 so that it can record FROM the SxS cards, However, it does not allow it to record TO the SxS cards.

Q: 2. What lens comes with the camera?

A: The lens, the lens boards, and the Fresnel screen are not included with the Intrepid Camera 4 x 5 View Camera.

Q: 3. Does this come as pictured or with the white laminate?

A: It looks like our current inventory is in this standard finish for the Alan Gordon Enterprises Hi-Hat and Low-Hat Mounting Board (Pre-Drilled with Screws).

Q: 4. 110 volt or 100 to 240?

A: 110

Q: 5. Which allen heath mixers of similar and also smaller size accept 100 to 240 volts?

A: The ZED 10 and the entire ZEDi series will accept 110 to 220 volts. You will need to change the shpe of the plug as it would come wth the US version.

Q: 6. I see full mix control for Str input 1 and mix control fot St 3. Is there no trim control for Str input 2?

A: Yes, there is no trim control for the ST2 input on the Allen & Heath ZEDi-10FX Compact Hybrid Mixer/USB Interface (with On-Board Effects Engine).

Q: 7. Has anyone tried this with video ? You could get a real "retro" effect, especially in B&W.

A: Yes, this lens gives a nice retro look in video.

Q: 8. Can I use this on my non-digital Canon Rebel2000? It does use the EF mount.

A: Yes the Holga Lens for Canon DSLR Camera, will work on Canon EF mounts, and should be fine for a Rebel2000 with EF mount.

Q: 9. What is the screw size and thread gauge of the screws that come with this?

A: We connected with Alan Gordon about the screws included with the Alan Gordon Enterprises Hi-Hat and Low-Hat Mounting Board (Pre-Drilled with Screws). Moreover, please note that only Alan Gordon Hi-Hats are compatible with the board. The screws and nuts included are: Cap screw is 3/8 16 by 1 1/4" Hex nut 3/8 16 nut Washers 3/8

Q: 10. Can the mix in the usb out of the ZEDi10 FX replace my iOS camera mic for live streaming? I have been using an Apple camera connector cable with no luck so far.

A: Yes, you can use the usb out for streaming. ZEDi can be used like an interface in DAWs as well recording individual channels. To my knowledge, OBS only supports a stereo sum of a usb audio signal. If that’s still the case, you could use a ZED10fx if your intent is only for streaming and not recording. The usb put on the ZED10fx sums to stereo over usb