The short-haired Big Windbubble from Bubblebee Industries provides some of the best wind protection for handheld microphones available today. The air enters the bubble for a short visit, finds it rather dull, and quickly leaves again without harming the microphone inside. So, instead of the wind hammering on the microphone and making those horrible sounds, it passes right on through.

The outside consists of our carefully chosen black faux-fur that is soft, fluffy and dense. It is built with the long fur as standard, and helps make sure that you get the best possible results when recording outdoors. There is a smooth mesh lining underneath the fur and an elastic mount at the bottom, which makes it easy and secure to fit the Big Windbubble on all standard handheld microphones.

Use with RX-CAM Receiver    Includes Short-Haired Big Windbubble    Protection for Outdoor Conditions    35 Hz to 20 kHz Frequency Range    Range up to 328'    One-Touch Pairing    Mute Switch, Low Handling Noise    128-Bit Encryption    Bottom-Mounted Diversity Antenna    2.4 GHz Fixed Frequency Agile Technology

Related Questions and Answers

Q: 1. Is this compatible with Fujifilm T20 mirrorless camera?

A: Yes, the Fujifilm X-T20 is under their compatibility list.

Q: 2. does this work with the rode videomic pro plus?

A: Yes, the Rode LB-1 rechargeable battery is compatible for use with the VideoMic Pro Plus.

Q: 3. Could this be attached to a camera or camcorder?

A: Rode SM4-R Suspension Shockmount BH #ROSM4R: https://bhpho.to/2Uj4Ri6 or WindTech Hot-Shoe Shotgun Microphone Clip CM-21 B&H # WICM21

Q: 4. What is the difference in this and the Crane M3?

A: The Zhiyun Crane M2s is smaller and lighter than the Zhiyun Crane 3M. The Crane M2s supports only 2.2 lb payloads while the Crane 3M supports heavier payloads of 14lbs with it's super strong motors.

Q: 5. What Blimp will work with shorter NTG5?

A: The Rode blimp. B&H # ROBLIMPR is the part number you can find it on the B&H website.

Q: 6. Is this a improvement to the NTG-4 or NTG-3?

A: At this point in time it would be difficult to tell. The NTG 5 does not arrive till Mid Nov 2019.

Q: 7. My old M2 would make a loud “Tilt! Tilt!” sound if it wasn’t perfectly balanced: is this the same & can you turn this noise off?

A: The Zhiyun CRANE-M2 S 3-Axis Handheld Gimbal Stabilizer will vibrate if too much torque is applied to the motors.

Q: 8. Can the stabilizer handle a Canon 80D?

A: Unfortunately, the Canon EOS 80D DSLR Camera (Body Only) is incompatible with Zhiyun-Tech CRANE-M2 S 3-Axis Handheld Gimbal Stabilizer Combo Kit. To view the compatibility list, see the link below: https://bit.ly/3MSkGXB

Q: 9. Is the WS-10 a deadcat?

A: The WS10 is the Furry Windscreen. Made for the Rode NTG 5.

Q: 10. Can the shock mount fit a smaller mic such as an Audio Technica 4053B?

A: Thr AT is shorter and fatter than the RODE. You should get the proper mount for each mic.