This pack of Short Shaft 1/4"-20 Male and Female Screws from Desmond consists of ten short-shaft screws. The screws have a 1/4"-20 male screw on top, and a 1/4"-20 female threaded receiver on the bottom. A plastic base allows the screws to be hand-tightened.

Short Shaft    Plastic Base Allows Hand-Tightening

Related Questions and Answers

Q: 1. How long is the 1/4-20 screw?

A: It is about 3/8s of an inch maybe a 1/2 inch. It is strong enough to hold the ICAN slider. The problem with the concept is that you only have one point of contact on each side of the slider. Not real a problem just an observation. Its strong enough to hold whatever weight your slder can hold.

Q: 2. I've got two 5" Joby Gorillapod arms that I want to connect together. They have the male 1/4"-20 threads on each end. Will this adapter work for this purpose?

A: This item does not have two 1/4"-20 threads on both ends unfortunately.

Q: 3. Are these Zinc Plated?

A: The CAMVATE 1/4"-20 Female to 3/8"-16 Male Screw Adapter for Tripod (2-Pack) are made of Stainless-Steel.

Q: 4. Does this screw work with the Sachtler Camera Plate 16?

A: It will fit the Sachtler plate. Be sure however, it is not too long for the plate and your camera. Too long and too tight and the screw will damage your camera.

Q: 5. Does this screw work with the Sachtler Camera plate 16?

A: This may work for your needs, but the Sachtler SKO12E0353 3/8 -16 Screw for Select Sachtler Tripod Plates is specifically designed for your plate: https://bhpho.to/2r2csnO

Q: 6. Gives the depth of the screw but does not give the diameter of the head. What is the diameter of the head?

A: The head diameter of the head with D ring is 5/8".

Q: 7. This item does not have the same dimensions as a real Sachtler screw (I just measured one.) Sachtler plates are notorious for needing an exact screw to hold a camera tightly. Why is this being advertised as a screw for Sachtler tripods? Can you independently verify this works with Sachtler tripods?

A: The Desmond Knurled 1/4 -20 Slotted Screws have the same measurement as Satchler QR Screws, with a length of 15mm.

Q: 8. Can it be installed on the stem of Gitzo GH3382DQ? I would like to use it as an adapter for RRS B2-LR II.

A: It is not compatible with the Gitzo GH3382QD.

Q: 9. Do these screws work with the Really Right Stuff One-piece L-bracket for the Nikon Z 7?

A: Yes, the Really Right Stuff One-piece L Bracket for the Nikon Z uses standard 1/4-20 sockets, so these screws should work just fine.

Q: 10. Can this fit the Mefoto camera plates?

A: The dimensions of these screws are 0.59 x 1.06 x 1.08 (1.50 x 2.70 x 2.75 cm) You can measure the plate and hopefully the Mefoto screw to check. It seems that these might be a little large in the ring and head. Unfortunately, it is not possible for us to go to our inventory to check here at B&H. Here are all the available quick release plate screws B&H has for sale. http://bhpho.to/1UC21jQ