The white D-SFRC8 Room Control Station for SourceFlex Distributed Audio System from RDL allows you to select between 8 different audio input sources and provides amplified outputs in addition to balanced and unbalanced line level outputs. It is designed for use where distributed audio with background music and paging are needed. The built-in Class D amplifier provides up to 3.5 watts of output. The front-panel volume adjustment knob can control the output volume of the amplified output.

A rear-panel switch set during installation causes the balanced line-level output to produce either a fixed +4 dBu or a variable level adjusted by the front-panel control. The unbalanced output is 12 dB below the balanced output level. The unit can be mounted in a wall box.

Select Between 8 Audio Sources    Amplified & Line-Level Outputs    Balanced & Unbalanced Line Outputs    Class D Amplifier    Volume Adjustment Knob

Single Room Listening Station with In-Wall Controls

Source Selection Pushbutton

Volume Adjustment Using a Single-Turn Control

Selection From up to 8 Audio Sources

Line-Level Audio Output

Line Output Switchable Fixed or Variable

Variable Output Follows Front-Panel Level Control

3.5 Watt RMS Audio Amplifier into 8 Ohms, 6.5 Watts into 4 Ohms

Class D Operation

Thermal and Short-Circuit Protection

Speaker Output Connection on Detachable Terminal Block

Mounts In Wall Using US Single Gang Electrical Box or RDL WB-1U

Related Questions and Answers

Q: 1. IS THE LONDON 8 BEIGE ALSO PAINTABLE?

A: Only the Paintable versions are designed to be painted. They are designed with a special formulation which enables the panels to be spray-painted without affecting the acoustic performance.

Q: 2. Can this be used to amplify a signal over a long speaker cable? I have a 5.1 system installed, but since the left front and left back speakers have longer wires, their signal is lower. My system allows me to boost the signal to these speakers, but it's not enough. I need more signal to these two speakers.

A: The RDL ST-PA6 is designed to connect from a line level device. It is not able to be used in line with speaker level input and output.

Q: 3. What material are the work surfaces constructed from?

A: The surface would be made of TruForm concrete.

Q: 4. Does it comes with power supply?

A: No, it does not. You will need the RDL PS-24AS.

Q: 5. Does it have warranty? If yes, how long?

A: 3 year warranty. You can see it listed in the "In The Box" section on your right-hand side of the Overview Tab.

Q: 6. Are the mounting options included in this package able to be used as ceiling clouds as well?

A: We do not recommend using the included mounting options for ceilings.

Q: 7. What is the part number for the power connector?

A: RDL PS-24V3A 24VDC Switching Power Supply with North American Cord is the correct power supply. B&H # RDPS24V3A

Q: 8. No specs listed. What are the dimensions? Weight? Etc.

A: These Luxor Reclaim Acoustic Room Dividers have the followings specs: Width in Inches 72 Depth in Inches 1.25 Weight (lbs.) 46 Height in Inches 64

Q: 9. Can you use the ethernet connection to send a signal to the Juke?

A: The Juke-6 40W 12-Channel Multi-Room Streaming Amplifier can accept audio sources over ethernet.

Q: 10. Need a low cost leveler for FCC Part 15 FM transmitter because input levels are not even. Will this work and how is frequency response affected?

A: This will help level the microphone audio. It will boost low levels and attenuate highs. It shouldn't affect audio frequency response for speech range.