Suitable for indoor or outdoor use, the PMAX-0822 is a gang box converter designed for ACTi A711 and A713 cameras.

Designed for A711 & A713 Cameras    Indoor/Outdoor Use

Related Questions and Answers

Q: 1. Can the unit be connected through the control port with a network switch?

A: The Blackmagic Design Studio Converter can provide external control and software updates which can be accessed through the control ethernet port. The connector will be enabled through software release.

Q: 2. Can I extend the range of Cat6 cable using some kind of signal amplifier or i will be always limited to 70m max?

A: When outputting over Cat6 cable from the Blackmagic Design Studio Converter, the maximum supported cable run would be 100m or 328 feet.

Q: 3. If i have a 5 camera set up how many fibre converters do I need?

A: You will need a Camera Fiber Converter and Studio Fiber Converter for each camera.

Q: 4. How does this connect to the Blackmagic Design ATEM 4 M / E Broadcast Studio 4K to use the intercom to talk to my cameras or what other equipment is needed to get the communication?

A: Directly through sdi input.

Q: 5. How can I connect a 2 wire or 4 wire comms system to the talkback channels on the ATEM Studio Converter?

A: There is no simple way to connect a 2-wire or 4-wire comms system to the talkback channels of the Blackmagic Design ATEM Studio Converter 2. Users often connect a 4-wire interface to the microphone input and the headphone output, and doing so would require careful level adjustment.

Q: 6. I am looking for a talk back device in the control room, i have an BM ATEM 1 ME, I have BM Studio Cameras connected to the ATEM 1 ME, I would like to communicate with the camera operators but don't have the talk back XLR's on my ATEM switch. I was hopping this device would give me the ability to talk from the control room to the other BMSC operators?

A: The ATEM 1Me will not give you any option for talk back.If your connecting the BMD Studio converter to a Black Magic camera converter with LC Duplex fiber (single mode) you can plug your head set into the BMD Studio Converter (located back at the production space) and talk to as many cameras that you connect to with fiber.

Q: 7. I am looking at integrating this with the BMD studio Pro camera over ethernet. The video tour and other documentation state that everything can be communicated via Cat6 ethernet. How does the "talkback" ethernet port out of this converter integrate into an intercom? What box would it plug into? Thanks!

A: As per Blackmagic Design: Cat6A or higher would need to be connected to camera. The Talkback RJ-45 outputs balanced analog audio to the camera headset system. It will connect to a 4-wire interface on the intercom.

Q: 8. Does this unit come with an optical fiber module and if so what kind is it?

A: Yes, the Blackmagic Design ATEM Camera Converter comes with the fiber SFP module in the box. It is the Blackmagic Design 3G SFP Optical Module. See the link below: https://bhpho.to/3n6fmr3

Q: 9. Are these compatible with the ATEM 2 M/E Production Studio 4K?

A: Yes, the Blackmagic Design Studio Fiber Converter can be used with the Blackmagic Design ATEM 2 M/E Production Studio 4K.

Q: 10. does this come with the rackmount kit as shown in the picture?

A: The Rack Mount kit is a separate option.