The Sescom SES-XLR-AB2 is an A/B stereo audio switch that enables you to route one stereo input channel (out of two possible stereo input channels) to one stereo output channel.

2 Stereo Sources to 1 Stereo Destination    Stereo A/B Switch    All Balanced Signals    Passive Design    High-Quality Locking XLR Connectors    Durable ABS Plastic Enclosure

• A/B switch with Center Off
• Passive design requires no power
• High-quality locking XLR connectors
• Lightweight and durable ABS plastic enclosure
• Input connectors: 4 XLR-male (two stereo pairs)
• Output Connectors: 2 XLR-female (One stereo pair)

Related Questions and Answers

Q: 1. Which sony cameras have the Digital Multi Interface Shoe?

A: The Sony A7R IV is the only model that supports Digital Audio through the Multi-Interface Show with this product.

Q: 2. Does this have an additional shoe mount on top?

A: No

Q: 3. Is there a headphone jack? Will it allow me to record 2 audio channels directly to RX100 VII while monitoring w/headphone?

A: This does not have a headphone jack. You may record two channels of audio to your camera thorugh the hotshoe but you wil need to monitor off your camera, which is better anyway.

Q: 4. can you monitor audio with audio out jack??

A: Yes you can use the audio out jack to monitor but you can't plug a headphone directly in the audio out jack and expect it to work as a headphone driver. The audio out jack is at microphone level and is matched to the microphone input on a DSLR camera. You would need an extra pre-amp to monitor the audio at line or headphone level from the audio out jack. However, the Saramonic BMCC-A01 has a dedicated headphone output with a volume control that works easily for audio monitoring of incoming signals. If you want to monitor incoming signals and audio playback from the camera when needed, then use the headphone jack on the camera as the place to plug in your headphones.

Q: 5. Is this compatible with the Sony FS7 to send audio to channels 3 & 4?

A: Based on Sony's website, this is not compatible with the FS-7.

Q: 6. will each input record to a separate channel on A6400, or will all inputs be mixed on one channel?

A: The input select switch on the back of the unit allows you to configure this unit to have inputs 1 and 2 recorded to separate tracks.

Q: 7. Is the shotgun mic mount removeable? If not, are there screws which look like I might be able to take it off with some customization?

A: Yes the shotgun microphone is removeable.

Q: 8. Does this unit have a limiter?

A: No, the XLR-K3M does not have a limiter, but it does have attenuation controls and low cut filters for Input 1 and Input 2.

Q: 9. what cables do i need connect to pc's?

A: Each device requires one 3.5 mm male to 3.5 mm male stereo audio cable. Be sure the one connecting to the computer is long enough to reach from the sound card headphone jack to the location of the switch.

Q: 10. What is the micro usb port used for?

A: The Sony XLR-K3M Dual-Channel Digital XLR Audio Adapter Kit with Shotgun Microphone does not have a micro-USB or USB port.