The  black PWB-270 Plasma/Flat Panel Display Wall Box from FSR is used with Crestron DM-RMC-SCALER-C Receiver and power supply, provided by Crestron, behind a wall mounted display or a projector. The scaler and power supply are mounted to a removable bracket which is in turn mounted to the PWB-270 back box.

The back box is installed flush with the wall’s surface, between either wood or steel studs. It includes mounting hardware and duplex box for convenience that can be mounted at either the top or bottom duplex knockout areas on the back box. There are two 1” and 1.25” concentric knockouts on the top and bottom for cable/conduit entry and cable tie (included) slots for cable management. The cover provides convection cooling for the internal components (sold separately).

Rugged 16-gauge steel back box

Simple installation

Mounting hardware is included

Connections and cables are hidden behind cover for a neat install

Related Questions and Answers

Q: 1. I have this mount but not the necessary hardware, what hardware is included in the hardware pack?

A: Universal hardware pack includes innovative universal spacersand M4-M10 screws. Mounting kit includes wood, concrete and steel stud attachment hardwarePlease contact the manufacturer directly if you seek a replacement hardware pack:P 714.632.7100 | 800.368.9700 | F 800.832.4888 | a href= http://www.mounts.com target= _blank www.mounts.com/a

Q: 2. Will this convert an analog 8mm video tape via camcorder to digital onto an external hard drive via laptop?

A: You would need to use this device to change your analog 8mm signal to HDMI and then connect that to a capture device (i.e. this Blutec USB model - https://bhpho.to/38fhT8F), which would then allow you to have your computer perceive the incoming signal in the same way it would see a webcam.

Q: 3. Is this product suitable for a mix of low voltage and high voltage application?

A: Yes it is.

Q: 4. With the SDI loop out be converted or will that be the same as the input signal? We need to convert SDI 25P to SDI 50i & HDMI 50i at the same time. Thanks

A: The SDI Loop Out will have the same signal as the input. It is best to use the Lumantek HDMI/SDI Cross Converter and Scaler for your scenario. Lumantek HDMI/SDI Cross Converter with Audio Mux/Demux and Scaler https://www.bhphotovideo.com/c/product/1445125-REG/lumantek_ez_md_hdmi_sdi_cross_converter_with.html

Q: 5. how many pounds?

A: About 8 lbs.

Q: 6. Can I use this for two light switches that will sit on a desk?

A: Yes. The FSR DSKB-2G 2-Gang Desktop Mounting Box (Black) BH #FSDSKB2G is designed to accommodate 2 switches.

Q: 7. Does this have a configuration or accessories for mounting in existing gypsum board/ wood stud wall?

A: It is designed to be mounted onto wood studs. It comes with appropriate hardware.

Q: 8. Does the converter cause any latency?

A: The Lumantek SDI to HDMI Converter with Display and Scaler will have a maximum of 2 frames of delay when converting to HDMI.

Q: 9. Is this a stainless steel product of some sorts or plastic?

A: This wall plate is composed of a Poly Carbonate material.

Q: 10. Does this box have rubber feet on it like the pic on the 2 gang box?

A: The FSR DSKB-1G 1-Gang Desktop Mounting Box (Black), BH # FSDSKB1G, includes rubber mounting feet.