The Two-Channel Power Amplifier from Crown Audio is compatible with the CXM2000 monitor and crossover system and DSi-8M monitor (available separately). It can drive 2, 4, and 8 ohms outputs. It supports parallel connection of cinema surround speakers and features power signal, clip, and fault indicators. This high-performance, lightweight, DriveCore based amplifier weighs less than 14 lb. The amplifier's input configuration supports stereo and parallel signals, and its output configuration supports stereo and bridge.

Compatible with CXM2000 Monitor    Capable of Driving 2, 4 & 8 Ohms Outputs    Power, Signal, Clip & Fault Indicators    Volume & Gain Control

Related Questions and Answers

Q: 1. Do these get alot heat?

A: It will get warm to touch which is normal: Internal heat sinks with forced air. Fan cooled, speed regulated, thermal protection

Q: 2. Is there an aux cord? or would I need the usb cord and then an adapter to the phone?

A: The CDi2000 is designed for commercial installations. The inputs on this power amp are 3pin phoenix connectors. If you are looking to connect audio devices to the amplifier, it is recommended to do so with a mixer which can be wired with adapters to the phoenix connector inputs of the amplifier.

Q: 3. Will this work in Australia which is 240 volts?

A: The Crown Audio XLi 3500 Stereo Power Amplifier that we sell is rated at 120V AC, 60 Hz for use in North America. However, you can use a step-down transformer to enable powering at 240V.

Q: 4. Does it have a fan? How noisy is it?

A: Yes, there are internal cooling fans included with the XLi 1500 that help to prevent the amp from overheating. The fans are fairly quiet, not noisy.

Q: 5. Can it be used for Bass amplification

A: Yes it can most definitely be used for bass amplification

Q: 6. How do you bridge the inputs so all 4 play the same sound ?

A: Bridge mode can be activated via a selector button on the back panel of the unit.

Q: 7. WHAT IS THE VOLTAGE OF THE CROWN XLI 2500 POWER AMPLIFIERS? THOMAS BROWN

A: The Crown Audio XLi 2500 Stereo Power Amplifier and the other Crown amps that we sell operate at 120 VAC, 60 Hz.

Q: 8. Do the Crown amps come with an EU cord?

A: The Crown Audio DCI8300N 8-Channel DriveCore Install Series Network Amplifier (300W) comes with a single power cord in a standard 15A IEC NEMA 5-15 configuration. This is the common, 3-prong US power connection. An EU compatible cable is not supplied with purchase.

Q: 9. Do you hear the fans when all is quiet?

A: On the XLi series amplifiers the fans do operate when the unit is idle. They may even increase in speed once the unit reaches a specific operating temperature. I generally recommend the amplifiers be housed in a closed rack enclosure to mitigate fan noise if the unit is going to be housed in the listening space.

Q: 10. Can this handle a 2 Ohm load?

A: No it is not designed to handle anything below 4 Ohms.