The white 1000' Genesis QUAD-Shielded Broadband Coaxial Cable Reel from Honeywell is tested to high standards to assure optimum performance in high-end home theater installations incorporating HDTV and digital video. Shielding protects signal transmission from EMI and RFI interference. The braid shield blocks lower frequency interference and foil shield blocks higher frequency interference.

General-Purpose CATV, CL2 Listed

Copper-Clad Steel: Common for broadband applications, including CATV/MATV and HDTV

Bare Copper: Good signal strength for low frequency applications such as CCTV; recommended for satellite dishes to power LNB (Low Noise Blocks)

Related Questions and Answers

Q: 1. where do i get this developed?

A: Fomapan R can be processed by the company DR5 Chrome, 701 W. 6th Ave., Denver, Colorado 80204-5008. However, they return the developed roll as 16mm, so you'll have to split it into 2-8mm strips yourself. Such a splitter is available on eBay.

Q: 2. To shoot the second time in the film the first time has to be erased? Should I change de position of the film or something?

A: Before shooting, you have to physically thread the film in the camera, though the film gate, from one film spool to the other. You then shoot one half of the width of the film. When you reach the end of the spool, you must go to very dark room, rethread it again and shoot the other and unused side of the film. There is no erasing with film

Q: 3. Will this length of double super 8 film(10m/33ft) fit in a Canon Zoom DS8 camera? This camera has a spool size of 100ft/30m, but since B&H is only selling this length, I was wondering if could just pop it in this DS8 camera with max spool size is 100ft.

A: It will work fine only keep your eye on the footage or meter counter and stop at 10 mt or 33 ft, and turn the film over -- whichever scale your camera has. I don't know the Canon but 100 ft rolls of DS8 and D8 were often sold on 16mm spools with a larger center hole. The Fomapan DS8 film comes on a spool with the smaller center hole. Worst case scenario will be to pass the film onto a 16mm camera spool or remove the spindle adapters from your camera if it has them.

Q: 4. What is the average time of recording at approximately 24fps with this roll?

A: The average record time for the Foma Fomapan R100 Double Standard 8mm Black and White Transparency Film (10m) will be about 2 minutes and 30 seconds.

Q: 5. Will this format fit my Brownie Movie Camera F/2.7 Lens Model 2?

A: Sorry No. This is the Super 8 version of Double 8mm film, and will only fit in the very few cameras ever made that can run DS8 (aka Double Super 8mm) film. B&H also offer this film in Double 8mm, just check their listing.

Q: 6. Will this film work with an auto zoom 814?

A: No this film will not work in your camera.

Q: 7. will this work on a bell & howell twenty-two 8mm movie camera?

A: As long as it isn't a super 8 or 8mm magazine camera then yeah. A lot of times they are called double 8. Just means there is a 16mm strip of film inside.

Q: 8. Do you shoot twice on this film?

A: Yes, you do shoot twice on this film.

Q: 9. Will this work in a Dejur Electra 8mm?

A: This film is NOT for super 8mm cameras. It is only for standard 8mm cameras.

Q: 10. Will this work in a Cine-Kodak K-100? The camera accepts single- or double-perf film and also has been converted to Ultra-16.

A: Yes, it will work, since your camera take single or double perf film.