The yellobrik HDMI to SDI Converter with 3D Support from Lynx Technik AG converts most HDMI sources up to 1080p60, including 3D material, to SDI. It features two SDI outputs, which support SD-SDI, HD-SDI, and 3G-SDI. In addition, the converter will pass up to 8 channels of HDMI-embedded audio into the SDI stream. Where extended cable runs are required on the output side, there is a Fiber SFP cage on the side of the unit that allows installation of the OH-TX-1 fiber optic transmitter, sold separately.

HDMI Input and Dual SDI Outputs    Supports SDI up to 3Gbp/s and 3D    Embeds HDMI Audio into SDI Stream    Fiber SFP Cage for Fiber Tx Module    Hard Transit Case    12 VDC Power Supply Included

LED light indicates the presence of an HDMI signal

Includes hard transit case

Will not pass HDCP-encrypted video

Related Questions and Answers

Q: 1. Will this allow me to rotate a video source 90 degrees?

A: Yes, the AJA ROI HDMI to SDI Mini Converter offers 90-degree rotation on the output.

Q: 2. Does this monitor record

A: No, the PORTKEYS HS8 does not offer internal video recording features.

Q: 3. Can it be powered by the mini usb port?

A: No, requires 12 volt power.

Q: 4. Can you apply a LUT to the HDMI out port? SDI port?

A: No, the FeelWorld Seetec SDI / HDMI Cross Converter cannot apply LUTs to any of the outputs.

Q: 5. BNC camera to HDMI?

A: This device will have a BNC connection, yes but it will be an SDI connection via a BNC connector.

Q: 6. Can you run the HDMI into a DVI adaptor to use with older Mac monitors being this is RGB out?

A: The HDMI input can be either YUV or RGB so this should work with a DVI-D to HDMI cable.

Q: 7. Does this reclock the signal as well?

A: Jake, I cannot see anywhere in the literature where it says that the HDSDI input will be reclocked; so I would have to say no, it does not. This is the dumbed down version of the MD-HX--to offer a less expensive conversion of a HDSDI signal to a HDMI one--or the reverse. Poor thing can't do everything! It's powered my a micro USB connection--cut it some slack. =

Q: 8. Sony DSR 300 or DSR 250 which has BNC connector can it be use to HDMI? Our church add a new room with two large monitor up front and all the AV is new. We are still using Sony DSR 300 and Sony DSR 270 which is great for us. The church has a wall plate and on that plate is audio and video connector. The video connector looks like it a BNC but it is HDMI. Is there anyway I can get the cameras to show on the monitor?

A: No, this is not compatible. It does have a BNC connection but it is an SDI output via a BNC connector. You should opt instead for B&H#: OCOMXCVHDMI with B&H # PEABNCRC1.

Q: 9. is the 12V+ input accept a 2.1mm or 2.5mm jack?

A: The standard power supply is a +12 volt 0.84A universal power supply. The contact sleeve is 5.5mm in dia. and a sleeve length of 9.3mm with a 2.5mm jack.

Q: 10. Can this downscale 4k DCI (through 6G SDI) into 1080p (through HDMI)? It says it can downscale UHD (3840x2160), but can it also do 4K DCI (4096x2160)?

A: Yes, it will do that but the max frame rate for DCI 4K is 24p. Max UHD is 30p.