The silver SwirlyGig Drink Holder by SwirlyGig is intended for use on 0.5" diameter tubing. It holds most common beverage containers including cans, glasses, water and beer bottles. It also holds other items like remote controls, phones, capos, reeds, pencils and picks. The inside of the basket is 3.12 x 4". It is simple to use and has no moving parts, with nothing to adjust or wear out. It fits snuggly in place, using only friction and gravity. It's made of resilient spring steel, then coated in protective PVC for grip and durability. It works great on lawn chairs, ice houses, crutches, lamps or any vertical 0.5" tubing.

Made in USA

Related Questions and Answers

Q: 1. Could these reflector hang from an extra tripod with a clip of sorts?

A: Yes.

Q: 2. Will this work on the minimax?

A: The following Easyrig Umbrella with Holder is for the MiniMax. Easyrig Umbrella with Holder for Minimax BH #EAERIGMM055

Q: 3. How to place an AirTag in this holder. I can’t seem to unscrew the item to place the AirTag in the holder. Any ideas?

A: With the Nanuk Airtag Holder, you have to slide out the plastic cover and you will see two screws. You have to use a Philips screw driver remove the screws and place the Airtag in the compartment. You can find a step by step guide in the instruction booklet the item comes with.

Q: 4. How wide do the clips open? I have some triangular manfrotto reflectors that have quite thick frames. Thank you.

A: Approximately one inch

Q: 5. Is this spring loaded or is the position and grabbyness set in a different way?

A: This is spring loaded

Q: 6. I just need the clips. Anyone know where can I find/buy them? (not available at b&h) Thanks.

A: Unscrew so easily... I don't know were to buy new one, but I took another clip that I have and drill a hole in it.

Q: 7. can this be used to hold a circular reflector horizontally, to create an overhead white surface for bounce flash? (like a white ceiling)

A: Yes it can hold a reflector horizontally. If you look at the magnified image of it you'll see that the two clips that hold the reflector are adjusted with a thumb turn screw. This allows the clips to not only slide along the arm but also rotate 360 degrees around the arm as well. So they can be turned horizontally. Or in any orientation to the arm.Just be aware you may need to add a bit of weight to help counter balance the arm for safety. As well as a sand bag for the light stand. Hope this helps.

Q: 8. Can the Impact Telescopic Collapsible Reflector Holder be easily mounted to a standard C Stand?

A: Yes it can. But I will also let you know the I've moved on from using this piece. I kind of hate it. Simply put, it has too many knobs that can come off or loosen on the road. I'm always shooting on location (everyday), I lost two knobs and bent a clip within the first couple of months. I knew that by replacing the missing pieces it would just happen again. So I purchased an Illuminating Arm instead. Less moving parts, less to worry about and hassle free.

Q: 9. Can the weight at the end be removed so the arm can be centered over the stand?

A: Yes, the weight is able to be taken off by simply unscrewing it.

Q: 10. Can the light stand mount be positioned between the two clips or do the clips both have to be on the same side of the light stand mount? I'm thinking about possible options for holding a 5x7' collapsible background. Thank you.

A: I don't have any problems with it. But moving a clip to the counter balance side would require a major modification to it. Not easily done at all.