The LH 28 TV-Spigot from Neumann is designed for mounting a monitor onto a lighting stand or G-clamp and truss bar. The 145mm wide mounting plate features two 11mm mounting holes. The 115mm high mounting spigot provides two indents to securely mount into a truss bar clamp or a lighting stand.

Active Studio Monitor

Digital Active Main Monitor

Mobile Powered PA-Speaker

Passive Studio Monitor

High Performance PA Loudspeaker

Ultra Compact PA Loudspeaker

High Performance Compact PA Loudspeaker

Mobile PA Loudspeaker

Related Questions and Answers

Q: 1. What is the distance between the two sets of mounting holes? Would these work with the rear mounting points of the Genelec 8010 speakers by chance?

A: The distance between the holes in the horizontal position is 4 inches. As for distance between the holes on the vertical end, the top hole distance is 1 1/2" while the bottom hole distance is 2 3/4". Unfortunately, this plate hasn't been tested with the Genelec 8010 speaker to our knowledge, so your results may vary.

Q: 2. metal or plastic?

A: The LH-11 Lens Hood is made of Aluminum.

Q: 3. What is the weight limit?

A: This can hold approximately 6-7 lbs at the most.

Q: 4. Can you use this hood and a UV filter at the same time?

A: Yes you can use a UV filter and the hood at once.

Q: 5. Hi Guys, this picture does not seem to reflect a double ended spigot with male threads on either side. Can you verify that the photo is accurate? thank you

A: It doesn't. Male one one end Female on the other

Q: 6. The 52mm screws directly onto the lens thread and then the hood bayonets onto the lens. This would be better than a filter plus generic hood combination that extends further? (Less vignetting)

A: The hood is made specifically for the Voigtlander Color-Skopar 21mm f/3.5 Aspherical lens. Other 52mm hoods might vignette the image or allow more flare since they were not made specifically for the 21mm lens.

Q: 7. is the ball swivel removable? leaving just the base and ball rod on ceiling?

A: The swivel can be removed, but it may be difficult to re-install it.

Q: 8. Does the QS-29 shoe plate work with the Vanguard MK-3 tripod?

A: Yes, this plate can work with the Vanguard MK3 tripod.

Q: 9. What are the dimensions of the plate size?

A: While the manufacturer does not list the dimensions of the quick release plate (as they are designed for specific tripods in their lineup) and we also do not have the dimensions listed on our website, I have found an online source that lists the dimensions of this item as 1-5/8" x 1-5/8" x 5/16" (42.04 mm x 42.04 mm x 7.95 mm).

Q: 10. What is the range of motion for the swivel, 360 degrees?

A: 360 degrees