The Data SureStrip Stripper/Cutter from Paladin Tools cuts and strips multiple cable types including 4-, 6-, and 8-conductor flat satin and UTP/STP data cables, as well as 25-pair UTP/STP data and telephone cables. It also cuts multi-conductor round bundled cables with a maximum diameter of 0.5".

Strips/Cuts 4-, 6- & 8-Conductor Cables    Strips/Cuts 25-Pair UTP/STP Cables    For 8-14 AWG Wire    Ambidextrous Design    Stainless Steel Blade

Strips/cuts 8-14 AWG wire

Nylon-reinforced ABS plastic with stainless steel blade

Fully adjustable with thumbscrew

Self-regulating to prevent nicking

Contoured finger grips

Lanyard holes for wrist straps or key chains

Small and compact

Ambidextrous design

Related Questions and Answers

Q: 1. Can I use the BOPP material outside?

A: The BOPP is a material is recommended for short-term outdoor use.

Q: 2. Is this model the 301-M?

A: Hello-this is the 301-1 model. It's great!

Q: 3. Will this work for terminating Canare BCP-B53 BNC ends? Looks like the opening for crimping the pin is a little off the 0.0531" spec.

A: You need the Canare TCD-35CA Die Set for BCP-B53, RCAP-C3A and FP-C3 Connectors or crimping tool that matches.

Q: 4. does this cut 8 ply mats and foam core?

A: I had difficulty getting it cut even 4 ply mats. The blade is not long enough.

Q: 5. can this cut foam that 1/2" thick?

A: No. The following unit will not cannot accommodate foam that is 1/2 inch thick.

Q: 6. Can anyone tell me what model dies come with this?

A: The Tempo PA4802 comes with RG6, RG6 Quad Die HDTV SMA (True 75 Ohm), BNC/TNC, Mini-UHF - RG174/59/62 Die HDTV BNC/TNC (CATV F True 75 Ohm) - RG59/6 Die SMA, SMB, Mini-59 BNC/TNC, and Mini-UHF - RG58/174 Die RG8/11/213 Die.

Q: 7. can it test up to 1,000 Mb/s?

A: The Greenlee NC-100 NETcat Micro Wiring Tester will not test up to 1,000 Mb/s.

Q: 8. can you also use this for general dry mounting tissue straight cutting?

A: Jay K. responded no , but I can't see why it wouldn't. With a sharp enough blade in the straight cutter the edge would act like any other straight edge. As with mat board, I would use the slip board underneath for the best chance at a good cut. You might try overlaying a thin veneer material to hold the material in place as well.Also, I have been cutting 8 ply mat board easily with ease on this tool. I soon learned to forget using the sliding cutting guide. It's ability to square with precision is useless - accurately measure and mark, then align with the the cutter bar works every time.

Q: 9. Can I use BOPP material outdoors?

A: While BOPP highly resistant short term, If you need the label to last longer than a couple of years Vinyl or Polyester will be a better choice.

Q: 10. can this crimp 3 piece UHD connectors that is compatable with Belden 4794R cable? Such as the SwitchCraft UHDBNC47 3 piece connector?

A: SwitchCraft makes a crimper for that connector https://bhpho.to/2OKRpDV.