This 6 ft BNC Male RG-6 Coax Video Cable from Kramer features 75Ω BNC male connectors that support all analog and digital BNC signals up to 3G HD-SDI. The cable consists of an 18 AWG solid bare copper center, skin foam insulation, and braid aluminum and dual aluminum Mylar foil dual shielding. The outside jacket is dark gray.

1-BNC Male to 1-BNC Male, 75Ω    18AWG Solid Bare Copper Center Conductor    Dual Shield: 61% Braid / Dual Mylar Foil    Skin Foam Dielectric    Low Attenuation / 100 ft: -0.3dB @ 1MHz    Supports Signals Up to 3G HD-SDI    Dark Gray Outside Jacket

−0.3dB @ 1MHz
−0.6dB @ 5MHz
−0.8dB @ 10MHz
−1.6dB @ 50MHz
−2.0dB @ 100MHz
−2.8dB @ 180MHz
−4.4dB @ 400MHz
−5.7dB @ 750MHz
−6.7dB @ 1000MHz

Related Questions and Answers

Q: 1. Will this fit into a SONY Cybershot DSC-H50 camera?

A: Yes. The Magnus FT-P15 MiniFlex Flexible Tripod for Smartphones and Camera will support the Sony DSC-H50 camera.

Q: 2. LANC specifies a 2.5 mm plug. Is this really 3.5 mm as you state, i.e. not a LANC connecor, or is it just a typo?

A: It's the LANC size. I use it with this Varizoom and it works great: https://a href= http://www.bhphotovideo.com/c/product/330007-REG/VariZoom_VZ_ROCK_VZRock_Variable_Rocker_for_LANC.html target= _blank www.bhphotovideo.com/c/product/330007-REG/VariZoom_VZ_ROCK_VZRock_Variable_Rocker_for_LANC.html/a

Q: 3. How long is this cable?

A: I don't have easy access to it, but from memory, it is about 6-8 inches long.

Q: 4. I wish to control a Vixia HF G30 with a Lanc miniplug port from a Sony zoom controller with a Sony Mini Audio Video cable plug. Do you have anything that will work?. I see that you have cable to go from land to Sony AV mini plug but I wish to do the reverse. Mike.

A: I am using this VariZoom adapter to go from a SONY CX-160 camcorder with an AV connector to my SONY LANC remote control model RM 870 tripod and it works works perfectly allowing smooth variable speed zoom control. It is far superior to the very touchy SONY RM-AV2 remote which was designed for the camera. I suggest you buy the VariZoom adapter cord from B&H. If it works, you're golden. If it doesn't work, return it immediately with an explanation. I have been buying from with B&H for over 20 years and never had a problem.

Q: 5. Will this D-Terminal to Component cable replace the Canon DTC-1500 cable that comes with the Canon xf-300 Camcorder?

A: I cannot speak to your specific camera- however a d-terminal is a d-terminal and mine was for a canon XH-A1 so it is very likely it will work.

Q: 6. Will this cable along with. The multi port adapter allow me to use a rocker zoom remote with my sony rx10 iv? Will that work on an rx10 iv?

A: no it will not. This is designed for older Sony consumer camcorders.

Q: 7. Can this record 4k 60 on each bnc?

A: It cannot, this product has four 3G-SDI inputs. It can accept 4K signals, but when using multiple SDI connections for the one signal.

Q: 8. Looking to build a 4k60 capable Windows-based video mixer (e.g., vMix) that supports SDI-inputs. What makes this 3G-SDI card more than twice the cost of the 12G-SDI from BMD (Decklink 8K Pro Cinema)?

A: The AJA card is probably priced higher than the Decklink from Blackmagic because the AJA card can do up/down/cross-conversion if you need to rescale anything.

Q: 9. Hello, Is one end of this for the shutter release female in on the Canon? Is that a 2.5mm to 3.5mm cable? Thank you.

A: No, the end of the Vello FreeWave Viewer Video Cable for Canon 5D Mark II is not for the N3 remote release port on the Canon EOS 5D Mark II DSLR Camera. One end of the above cable is designed to plug into the Vello FreeWave Viewer, and the other end is designed to plug into the A/V OUT Terminal on the side of the camera, shown on both pages 16 and 157 of the Canon EOS 5D Mark II DSLR Camera's instruction manual.

Q: 10. How long is the cable?

A: The VariZoom Mini Audio/Video to LANC Converter Cable for Select Sony Handycams (B&H# VAVZAVLANC) is about 16.5 inches (42cm) from tip to tip.