The 10' DisplayPort Male to HDMI Male Cable from Kramer allows you to output video and audio from a DisplayPort source to an HDMI-equipped device, including a display or HDTV.

Connects DisplayPort to HDMI    1 x Male DisplayPort Connector    1 x Male HDMI Connector    10' Length

Related Questions and Answers

Q: 1. Is the PC Male Pin compatible to the Olympus OMD M5ii? If not, which cable will fit?

A: You will need # VEHSAPVU to make it work

Q: 2. Can this clamp be used with an accessory/handle connected to the Arri accessory mount on the left side?

A: Yes, it appears there is just enough clearance to use the 3/8"-16 thread with ARRI locating pins at certain positions.

Q: 3. With this work with a RB67, to fire a wireless flash transmitter, specifically a cheap unit like the Yongnuo YN-560-TX?

A: On-camera flash made by Canon, Nikon, Panasonic, Fujifilm, Samsung or Olympus with a radio receiver. It is not designed to work with a Mamiya RB-67.

Q: 4. Will this work with the Fuji Film XT3 micro HDMI port?

A: As long as you have a cage for this attach to, it should work just fine for the Fuji Film XT3 micro HDMI port.

Q: 5. On a Z7, will this cable fit with the WR-R11b wireless transmitter attached to its terminal? (The WR-R11b interferes with fitting a standard 3rd party HDMI mini cable)

A: No, Nikon HC-E1 HDMI Cable (9.6') would not fit your Nikon Z7 mirrorless camera while the Nikon WR-R11b Remote Controller is connected.

Q: 6. Why is this cable different from a standard type C to type A HDMI cable? The price is several times higher.

A: The cable is a standard Male Type C Mini HDMI to Male Type A HDMI. As for price there are other brands that are around the same price and others that are less.

Q: 7. can I use this to connect my Metz ring flash to Sony A7rii ?

A: I am not familiar with the either Metz ring or the Sony A7RII. This PC cord was first made decades ago for the cameras and flashes of the time. It may also work with some newer equipment. I use it with vintage Nikon rangefinder cameras of the 1950s with Nikon Speedlights of the 1980s. It also works with my Nikon FX DSLRS and a vintage Rollei TLR.

Q: 8. Im trying to connect my hasselblad 500cm to godox xproC, is this cable going to fire my external flashes via the godox xpro? I got ad200`s

A: Yes this will allow you to use a XPro to five a AD200. Since it will be manual you can use any of the XPro versions.

Q: 9. Will this work to secure the USB cable on the SmallRig 2129 Cage for the D850? Not just the HDMI.

A: Sorry, no. It is not tall enough.

Q: 10. What screws should I use to mount the plate?

A: The Ursa mini has a blank plate installed from the factory. When you remove the blank plate, you can re-use the screws to mount the AB. I didn't need to purchase anything extra to install it, it was very easy.