The DisplayPort Male to HDMI Male Cable from Tera Grand is a directional 6' cable that allows you to connect a DisplayPort-equipped source to an HDMI-equipped device such as a display or projector. This cable has a locking DisplayPort connector.

Male DisplayPort Input from Source    Male HDMI Output to Display    Directional Design    Supports Resolutions up to UHD 4K, 30 Hz    Locking DisplayPort Connector

Related Questions and Answers

Q: 1. will this work with adobe premiere pro cc 2017 on imac retina 5k?

A: Yes, this card is compatible with both Adobe Premiere Pro CC 2017 and Apple's OS. However you will need an expansion chassis to connect the PCI-E Card to the computer. If your computer has Thunderbolt 3, that would be the most ideal option.https://bhpho.to/2kUiK4p

Q: 2. What is the size of the fuse in side the plate?

A: The manufacturer does not explicitly provide this specification. We invite you to pose your inquiry directly to Anton Bauer at: https://bit.ly/3lP86cw

Q: 3. Is the PC Male Pin compatible to the Olympus OMD M5ii? If not, which cable will fit?

A: You will need # VEHSAPVU to make it work

Q: 4. Can this record 4k 60 on each bnc?

A: It cannot, this product has four 3G-SDI inputs. It can accept 4K signals, but when using multiple SDI connections for the one signal.

Q: 5. Does this work for Alpha 1?

A: Yes, this cage can fit the Sony A1.

Q: 6. Is there a foot that will work with this monopod?

A: This has a 3/8"-16 connection on the bottom. Any foot using that connection will fit. For example the feet in the set linked here would work. https://bhpho.to/3wLDVtn

Q: 7. Can this clamp be used with an accessory/handle connected to the Arri accessory mount on the left side?

A: Yes, it appears there is just enough clearance to use the 3/8"-16 thread with ARRI locating pins at certain positions.

Q: 8. Does this work with the Sony A7IV?

A: No. The following unit is formfitting camera cage for Sony a7S III

Q: 9. Will this work with the Fuji Film XT3 micro HDMI port?

A: As long as you have a cage for this attach to, it should work just fine for the Fuji Film XT3 micro HDMI port.

Q: 10. Is this compatible with the Andycine C5 5.5 Monitor?

A: Yes, this can be used with the Andycine C5 5.5" monitor.