The white D-RLC3 Remote Level Control, Preset Level from RDL is designed to directly interface with control modules which feature a 0 to 10 VDC control input utilizing an external 10kΩ resistive control, such as the ST-VCA3, RU-VCA2A and RU-VA6A voltage controlled amplifiers. The D-RLC3 has four momentary push buttons, each corresponding to one of four levels selected.

In a typical installation, the D-RLC3 is wired to a RDL VCA. The D-RLC3 runs from the same power supply as the VCA. When power is applied, the unit defaults to the NORM level. One higher level, HIGH, and two lower levels, LOW and MIN, are then available for selection. When the device is set to the HIGH position, the VCA is at maximum gain. The NORM, LOW, and MIN levels are each adjustable using trim pots on the side of the level control. The adjustments are concealed once the unit is installed.

The D-RLC3 is constructed on a durable polycarbonate-faced, powder-coated steel panel. Electronics are housed in a metal enclosure featuring a rear panel detachable terminal block for easy wiring.

Four momentary pushbuttons, each corresponding to one of four levels selected; LOW, MIN, NORM, and HIGH

Once installed, the adjustment trimmers are concealed from the user

Related Questions and Answers

Q: 1. Will this fit the Sunpak 800i UT?

A: I bought one for my 800i UT a year and a half ago and it fit.

Q: 2. Will this be compatible with a QSX 2001 tripod?

A: Yes, the Sunpak 620-731 is compatible with the QSX 2001 tripod.

Q: 3. Will this work with Quantaray QSX 9500 tripod?

A: You will need the 620-733 quick release for the Quantaray QSX 9500 tripod.

Q: 4. Can this convert a 3.5mm mono mic level input to line level signal?

A: No, the ART CLEANBoxPro Bi-Directional Level Matching Converter is not a preamp, and will not properly amplify a mic signal coming from a 3.5mm cable.

Q: 5. will this fit with the Sunpak 5800D platinum plus?

A: Comparing the sizes of the two quick releases, the bottom foot dimensions are off by a millimeter or so. So I think you have a good chance with this. If you do not like chances, here is a company that specializes in quick releases, especially hard-to-find entry level tripods. https://bit.ly/2AvGgQf

Q: 6. is the base 35mm x 35mm ?

A: I am not sure about the dimensions you asked about, but the replacement fit my Sunpack tripod.

Q: 7. Are the feet/sides removable? I'm hoping to fit on a 1RU rack shelf and I see listed dimensions are currently a bit too big at 1.85"

A: The feet are not removable.

Q: 8. Do I need a screw to install?

A: The Desmond DAC-100B 100mm Skeleton Clamp with Removable Level has a 3/8"-16 female socket and includes a 1/4"-20 reducing bushing adapter. So it will fit on any tripod screw.

Q: 9. Will this work with a Quantaray Titan Series QT-100 tripod? And if not what part will.

A: Your tripod requires the 620-736B plate. Please see the following link:http://bhpho.to/1mck1ev

Q: 10. Will this work with Canon Deluxe 200 Tripod?

A: This quick release plate is not compatible with the Canon Deluxe 200 Tripod. You will need to contact the manufacturer directly for a replacement.