This is an empty Military Standard Waterproof Case from SKB. It is a water and airtight gasket sealed submersible case built to be UV, solvent, corrosion and fungus-resistant. Construction is made from an injection molded polypropylene copolymer resin that is also impact-resistant.

A pressure equalization valve is included to balance the ambient and enclosed gases that accumulate during transit. This helps maintain the integrity of the case's seal. Accessing the interior is via a four trigger release latch system. The rear hinge is molded-in for strength. The carry handle features a rubber over-molded cushioned grip. There are locking loops that will accept a user-supplied lock.

Water, Airtight / Gasket Sealed    Injection Molded Polypropylene Resin    UV,Solvent, Corrosion,Fungus-Resistant    Pressure Equalization Valve    Trigger Release Latch System    Molded-in Hinge    Rubber Grip Handle    Accepts User-Supplied Lock

Related Questions and Answers

Q: 1. What are the exterior dimensions?

A: Exterior Length:21.26 in Exterior Width:16.75 in Exterior Depth 9.83 in Exterior Cu. Volume: 2.03 cu ft

Q: 2. Will this case work and fit as an airline carry on. Thnx.

A: Each air lines have their own size specifications so it is a good idea to contact the specific airlines for that.This is around the size the bag can be at the largest, The maximum dimensions cannot exceed any of the following measurements: 22 long x 14 wide x 9 tall or 115cm (56 x 36 x 23 cm). The case you are referring to is, 19.00 x 14.38 x 8.00 (48.26 x 36.53 x 20.32 cm). So it is just a bit too wide.

Q: 3. Is there a version with precut foam that fits the a7ii body design?

A: Unfortunately at this time there is not a newer version for the Sony A7 ii yet.

Q: 4. TSA Locking latch kit for this particular model?

A: You could use a TSA Lock accessory with the iSeries DSLR Pro Camera case, yes.

Q: 5. What is the diameter of the two lens holes?

A: The lens space diameter on the pre cut foam that comes with SKB iSeries DSLR Pro Camera Case I (Black) is 91mm. The hight is adjustable from 5 inches to shorter lenses.

Q: 6. Will the cut-out in this case fit the GoPro Hero 4 Black?

A: Sorry, we don't own a 4 - we have a 2 and a 3 packed into it and love it for those. Think the 4 may be a little smaller, so yes it will fit, not sure how securely.

Q: 7. Can SKB series 1309 hold Fuji XT-3 with grip and L bracket in vertical position (5.75 inches or 146mm) with foam padding in lid?

A: Hello Walter Unfortunately, the camera will not fit in a Vertical position, only if you were to lay the camera flat.

Q: 8. Do they make a lid organizer that works with this case?

A: Unfortunately, there is no compatible lid organizer for this particular case.

Q: 9. Would a Dell XPS 13 fit in the laptop pocket?

A: When using the SKB iSeries 1309-6 Case with Think Tank Photo Dividers & Lid Organizer, a Dell XPS 13 should fit into the "laptop pocket"

Q: 10. I have a D7200 Nikon with an 18-140 lens, will this case hold this camera in addition to maybe one more lens and a light meter and some filters?

A: Yes, my 7100 fits with a larger lens. The extra lens slots will also hold the 18-140 but not a longer lens like the xx-300. Filters will fit along with a medium size flash. You could fit two more lenses.