The black Canare L-5CFW RG6 BNC Male to Right Angle BNC Male HD-SDI Video Cable is a 175' cable that is hand-assembled with Canare extra flexible L-5CFW HD-SDI RG6 coaxial cable, and Canare true 75-ohm HD BNC connectors. This cable is 100% sweep tested to conform to SMPTE 259M, 292M, 424M, 2081-1, and 2082-1 standards. The combination of Canare BNC connectors used in this series exceed 3.0Gb/s HD-SDI requirements specified in SMPTE 424M and are fully rated for extended distances for 3G-SDI ST424 out to 340 Feet.

18 AWG RG6 SDI Coaxial Cable    BNC Male to Right Angle Male Connectors    Solid Copper Center Conductor    Foam PE Dielectric Insulation    Dual Copper Braid    100% Sweep Tested

Hand made with Canare L-5CFW 18AWG stranded center conductor, 75-ohm Precision HD-Serial Digital Video Coax cable for professional broadcast performance

Cables meet SMPTE 259M, 292M,3G 3G 424M, 6G 2081-1, 12G 2082-1 Standards

Canare BCP-B51F straight, and BCP-LC5F right angle, true 75-Ohm BNC connectors, exceed 6.0Gbps HD-SDI SMPTE requirements

Dual copper braid for flexibility and bending performance

100% sweep tested

Related Questions and Answers

Q: 1. Does this kit come with screws needed to mount the support to the lens?

A: Yes, this kit should come with everything you need to attach it to your lens.

Q: 2. The two answers to the previous compatibility question are unclear. Would this finder fit my Wista 45 VX?

A: Unfortunately, the FotodioX Pro Right Angle View Finder Hood for 4x5 Wista Camera will not fit the Wista 45VX.

Q: 3. Would this work with the Sound Devices MixPre-3 II audio recorder?

A: This is regulated to work with select GoPro cameras. We are not aware of it being able to work with a Sound Device Audio Recorder.

Q: 4. Is this compatible with the Cinegears 150m Receiver?

A: No this is Not compatible with the Cinegears 150m Receiver

Q: 5. Does this transmit audio over both the SDI and HDMI? My unit does not seem to have audio and I can't find a setting for it.

A: It should transmit audio. Check the output of your camera

Q: 6. Which end connects to the camera, the transmitter or receiver?

A: With systems like this you Transmit the signal from the camera to a monitor that has a receiver on it. The Transmitter will go with the camera.

Q: 7. can it be used with two receivers at the same time? Which receiver is correct for this transmitter?

A: There must be a one to one relationship between the transmitter and receiver.

Q: 8. it says you can power the transmitter via dtap butcan you power the reciever with a d tap?

A: Yes, both tx and rx can be powered via p tap to 2 pin lemo cables.

Q: 9. Can the receiver output HDMI and SDI at the same time to enable a loop to another monitor?

A: Yes you can. If using a smallhd monitor you can just run one sdi out to that, and loop out of the smallhd as well.

Q: 10. Can you use two or three of these in one location or will the signals interfere with each other?

A: You can put each set on a different channel, so it should work just fine