The 25' TAC1 Simplex Singlemode ST Fiber Optic Tactical Cable from Camplex is designed for broadcast applications requiring an outdoor rated crush and impact resistant design. The polyurethane core-locked design will be found where ordinary PVC jacket cables do not provide adequate protection in the field. The cable is machine polished and interferometer tested to industry standards.

Designed to Withstand Impact    Indoor/Outdoor Rated Jacket    Polyurethane Core-Locked Design    Rugged & Lightweight    Broadcast Deployable

Broadcast deployable

Indoor/Outdoor rated jacket

500 Micron primary acrylate buffer with 900 Micron secondary hard elastomeric buffer (Ultra-Fox Plus)

Crush and impact resistance due to their polyurethane core-locked outer jacket

Designed to withstand crush and impact after deployment

Strong, lightweight and durable

Temporarily deployed cables that can be retrieved for repeated use

Related Questions and Answers

Q: 1. It works with KOMODO TILTA KIT A?

A: We have not tested that particular pairing. The recommended baseplate for that Kit A is https://bhpho.to/3JO7SQg

Q: 2. Is this compatible with the Tilta Xh2S cage?

A: Yes, the Tilta Tiltaing 15mm LWS Baseplate Type IV (Black) would be compatible with the Tilta Basic Camera Cage Kit for FUJIFILM X-H2S/X-H2 with the Tilta Manfrotto Quick Release Plate for FUJIFILM X-H2S Cage (Black), BH #TIAT36QRBPB, attached.

Q: 3. How much space is needed to set up and use the cutter? TIA

A: The working space would need to be larger than the length of the trimmer which is 46".

Q: 4. Do you need to use this cutter on a table top, or can you mount it on plywood for a wall mount?

A: This Logan 750-1 Simplex Elite Mat Cutter works best on a table top.

Q: 5. does this cut 8 ply mats and foam core?

A: Logan Graphics 750-1 Simplex Elite Mat Cutter (40" Cut Length) BH #LO7501 comes with the 701-1 Straight Cutter that cuts up to 3/8" foam board and the #5000 8 Ply Bevel Cutter that cuts 8 ply mat board.

Q: 6. What size Arca Swiss mount do I need to fit the included Arca Swiss Plate?

A: The Tiltaing Lightweight Kit for Sony a7S III (Tactical Gray) (B&H# TITAT18A) has an Arca-compatible dovetail on the bottom of it for mounting it in an Arca-compatible quick release clamp. It is a particular standard, so it will fit in most Arca-swiss clamps. Here's a good example of one: Oben QRA-A2 Quick Release Assembly with QR-10 Plate (B&H# OBQRAA2) https://bhpho.to/370LpRf

Q: 7. Compatible with the Sony a7 IV?

A: The Tilta Half Camera Cage for Sony a7S III would only be guarantied to fit the A7SIII. But it should work with the A7IV as well.

Q: 8. Dues it include f570 battery this kit?

A: No it does not. NP-F570 batteries are not included.

Q: 9. How does one attach a manfrotto base plate without it wiggling on the Titla center screw ports? The Titla has only a thin ridge with no support on the sides for these plates!

A: Using 2 screws to secure the baseplate to your tripod plate will prevent it from wiggling or rotating.

Q: 10. Does this accommodate a typical arca swiss baseplate?

A: Yes, via 1/4"-20 threads