Secure your mobile device with the bulk packed RAM MOUNTS Mighty-Buddy Snap Link Suction Cup Mount with Universal X-Grip Cellphone Holder. Designed to fit most smartphones, this mount has a twist-locking suction cup base that holds firm to flat glass and non-porous plastic surfaces as well as adhesive disks. It's made from high-strength composite and marine-grade stainless steel for longevity. The spring-loaded X-Grip cradle expands to hold your device and has rubber tips to prevent scratching. The included Tether adds security for open-cockpit applications.

Fits Most Smartphones    Twist-Locking Suction Cup Base    Made From Composite & Stainless Steel    Rubber Tips Prevent Scratching    Tether for Open-Cockpit Use

The cradle can be oriented horizontally or vertically depending on the size of your device. It holds smartphones 1.875 to 3.25" wide. Devices at the minimum (1.875") width must be at least 4.25" long, while devices at the maximum (3.25") width must be at least 2.25" long. Maximum depth is 0.875". Please measure your device with the protective case or sleeve that you plan to use.

Related Questions and Answers

Q: 1. Is this compatible with the Manfrotto 035RL Super Clamp with standard stud?

A: Yes this clamp can fit a 5/8" stud normally included with the Manfrotto 035RL.

Q: 2. Will BH #WAAM198BHLE work with BH #APLSC120D23A ?

A: Yes, this battery will be compatible with that light.

Q: 3. how do I release the cup from any surface? The surface is vertical and what I believe to be the release is underneath and I cant see it.

A: There is a rubber tab protruding from the side of the suction cup (same color/material as the cup itself). Place your thumb under it and push up; the suction will release.

Q: 4. I want to sue these for a rail with a suction cup on each end. Can I insert a 5/8" diameter rod into this and clamp down on it?

A: It could be used with a 5/8th rod as that is the size of a baby pin.

Q: 5. Can this mount to a light stand?

A: Yes. You will need the C-stand knuckle. When it's set up remember to either sandbag your C-stand securely or make sure that the cantilevered mic/boom pole don't tip the C-stand over.

Q: 6. Would this work with a rode shotgun microphone?

A: This combination is great to hold a microphone boom pole that you could the attach a shock mount to and thus a rode shotgun to that. It would not work to hold the shotgun by itself.

Q: 7. Watson Pro Buddy System High-Load V-Mount Battery fit/works with c200 canon ?

A: If you are using a V-Mount Battery Plate with your C200, such as B&H # WO214700, then yes this battery will work with it. https://bhpho.to/2TW0nfO

Q: 8. Is this similar to the Manfrotto one, are they the same?

A: Thank you everyone.

Q: 9. Can this be attached to a light stand?

A: yes it can

Q: 10. Is the grip head in this kit smaller than a standard grip head that comes with a typical C Stand? I already have a C-Stand with grip head but am hoping this is smaller, so I can use it for travel with a travel light stand and sand bag counterweight.

A: Hi Sheldon, I believe they are a standard size. Hope this helps :)