The 160W UP 2161 Power Amplifier from RCF is equipped with a Microphone/Line main input via a removable connector, an XLR connector, or an RJ45 port. The amplifier also features an RCA Auxiliary input for music sources such as CD players and tuners. The amplifier output is available for either low impedance speakers or 100-70 constant voltage line. The Class D amplifier features a switching power supply. The UP 2161 is designed for the transmission of announcements and musical programs. It is ideal for use in restaurants, shops, supermarkets, hotels, offices, department stores, industrial systems and similar applications.

160W RMS digital technology power amplifier

Main input on either removable connector or XLR or RJ45

Main input can have priority over the aux input

Main input has a presence control command

Main input has a high-pass filter useful for improving speech intelligibility

Aux input for music sources on RCA type connector

Aux input with volume and tone controls

100 V - 70 V and 4 ohm outputs

Front panel LEDs indicate the device state (ON, PROT), the priority activation (PRIOR) and the signal/peak level (SIG/PK)

Related Questions and Answers

Q: 1. Can a powered subwoofer be connected to the REC OUT jacks?

A: The REC OUT on the Pyle Pro can be used with a powered subwoofer, however the signal output from this set of jacks is not affected by the master volume. If you turn down the main volume, the incoming signal is still fed to the connected device (subwoofer).

Q: 2. Can I use 98Wh Li-ion V-Mount Battery for the LC-120 and how much time I will have at full power ?

A: The Intellytech LiteCloth 2.0 LC-120 Foldable 1 x 3 LED Mat Kit (V-Mount) can run on a 98Wh battery. At full power it will last at the most 45 minutes to an hour.

Q: 3. What is the output ohms for the speakers?

A: its 4-8ohms

Q: 4. can these two channels be bridged?

A: to the best of my knowledge, no. Basic 2 channel amp, but it does what it is supposed to do well with low distortion and dependable output levels. I used it for wired speakers on my patio, Bose, that are not that efficient, but it drives them well and cleanly. Hope this helps.

Q: 5. would this help old turntable without preamp for use with speakers with phono hookups on the main speaker i use old 70's realistic turntables without preamp and won't work with the new speakers i recently purchased

A: Definitely. I love mine.

Q: 6. PTAU45 - What is the frequency response of this amp?

A: the frequency response, as listed in the owner's manual, is 20Hz-20kHz

Q: 7. PTAU45 POWER STEREO AMP: What is the frequency response of this amp?

A: Frequency response is rated at 20Hz-20KHz. We connect all sorts of electronics to these and find there sound quality to be just fine for small to medium group listening. Your speakers will likely be the limiting factor if you choose to run these amps for these groups.

Q: 8. Is this light compatible with the element lighting board?

A: The SWIT S-2320 160W Bi-Color Studio LED Spot Light supports DMX. It has 5 pin dmx ports.

Q: 9. Can I connect my nextbook for better sound?

A: You can hook up any audio source with an auxillary cord. I've used phones, iPads, and IPods without an issue so I'm assuming your Nextbook would be similar.

Q: 10. Does this allow microphone to be used at same time with other sound source like aux? So is it a mini mixer+amplifier likely thing?

A: Correct: Switchable MIC PAGER and MIXING ModesSet to PAGER, the signal from AUX 1/AUX 2/CD will be attenuated BY -12dB and the signal from MIC will override to page (Auto Talkover), it is good for paging system. Set to MIXING, the signals from AUX 1/AUX 2/CD and MIC will be existed at the same time, it acts like playing at KARAOKE event.