Extend the run time of your Stella or Seca series lighthead with this 3-Cell Battery from Light & Motion. It is available here as a replacement or spare for the one included with your light and includes a strap with hook-and-loop fasteners for attaching it to your setup.

For Stella and Seca Lightheads    Extends Run Time of Light    Hook-and-Loop Fastener Strap Included

Seca 2000 Race
Seca 2000 Enduro
Seca 2000 Sport
Seca 1500
Stella 500
Stella 500 Sport

Related Questions and Answers

Q: 1. What is the maximum duration of a pan one can set this to? (On external power). I would like to do a six month time lapse.

A: The Syrp Genie Mini II Panning Motion Control System can operate for up to 15 hours at a time on the internal battery.

Q: 2. Can this paired with and control the original Genie Mini?

A: Yes, it works fine as a tilt/pan setup with the original Genie Mini and the Mini II.

Q: 3. What is the USB-C to USB-A Female Cable used for?

A: It gives you the option to charge the Genie from either a USB A Port or USB C port.

Q: 4. What cable to use with the Olympus OM-D E M5 Mark II camera?

A: The Olympus OM-D E M5 Mark II would work with the 3L shutter cable https://bhpho.to/3ODn3gs

Q: 5. Does it hold a charge when in storage? The first genie mini would lose all charge when stored for extended periods, must of had a constant power draw inside. Is this problem fixed?

A: There may be a slight drain when not used over a prelonged period. It is a best practice to fully charge any product before using it.

Q: 6. Can this be used with a Hasselblad X1d or X1d mkII? If so, which cable is used?

A: The Syrp Genie Mini II Panning Motion Control System supports up to 8.8lb payloads. However, at this moment Syrp does not offer Hasselblad camera control cables.

Q: 7. Where are the 1/4 Mounting points?

A: In this image, the 1/4 mounting holes on on the near and top sides of the bracket.

Q: 8. When pairing the genie mini 2 with genie 2 for slide and pan moves, are all the controls on the same app? or do you have to bounce between two apps? if that's the case, does this cause problems with the system?

A: When using these within a multi motor kit, the motors will all be controlled within the same app.

Q: 9. which cable would I need to purchase for use with a fuji XT3?

A: BH #SY17007 is the proper cable to use with the Fuji X-T3. https://bhpho.to/36vmQqM

Q: 10. What cable do I need to sync this with a Canon EOS R?

A: The Syrp 1C cables are compatible with the Canon EOS R5: https://bhpho.to/3bmR5Ec