The medium IP-M Isolation Pad from Auray is a monitor speaker isolation pad made from high-density acoustic foam. It is designed to decouple your monitor speakers from its resting surface by absorbing the monitor's vibrations. This stops reverberation through the desk or speaker stands, therefore preventing unwanted resonance. Removing these unwelcome vibrations results in greater depth of field, tighter low end and transient response, and a higher level of detail across the frequency spectrum.

Prevents Resonant Coupling    Reduces Vibration & Acoustic Energy    Greater Depth of Field    Greater Detail Across Frequency Spectrum    Tighter Low End & Transient Response    Improved Stereo Imaging    High-Density Acoustic foam    Set Speakers at Three Different Angles    10.25 x 13" Surface Area

Up position: Angle your speakers up for desktop use

Down position: Angle your speakers down for use on a monitor bridge or shelf

Flat position: Flip the pads upside down to set your speakers flat on adjustable speaker stands

Related Questions and Answers

Q: 1. will this work for a feelworld ma5 5 inch monitor?

A: Yes it will. The Feelworld MA5 uses NP-F style batteries.

Q: 2. Planning on getting the Shinobi, will it work with these battery? Also if I pick up just this battery how to do charge it?

A: yes this will work with the Shinobi. you will also have to buy a charger with the battery

Q: 3. is this a mini XLR connection at the shock mount?

A: No. The top of the shockmount has a standard XLR female connector so that the connector from a gooseneck mic can plug directly into it.

Q: 4. Will a Yeti Blue Mic fit inside this? With the base on my desk?

A: It is possible to fit the Blue Yeti USB Microphone with the attached desktop base inside the Auray VOCDOC-ISOMD Microphone Isolation Chamber; however, it is recommended to mount the microphone to the Blue Radius III Shock mount for Yeti and Yeti Pro USB Microphones for better vibration absorption.

Q: 5. Does this work for the blue yeti?

A: Yes, you will have to remove the base from the Yeti and attach it directly to the mic holder, or for better results, use the Blue Radius III shockmount for Yeti. https://www.bhphotovideo.com/c/product/1385874-REG/blue_radius_iii_shockmount_for.html

Q: 6. Will a Shure SM7B on a stand fit inside this?

A: The Shure SM7B Vocal Microphone (BH #SHSM7B) will work inside the Auray VOCDOC-ISOMD Microphone Isolation Chamber (BH # AUVODOCISOMD).

Q: 7. How long does it take to charge the batteries in this kit with the included charger?

A: These should take between 3-4 hours.

Q: 8. Will this work on the ninja blade?

A: Hello Too F, yes it also fits for the Ninja Blade unit.

Q: 9. Is there an XLR connector on the wire or will you need to solder one on?

A: The built-in XLR onnector is attached to a 6' Balanced Line Cable which would need a connector.

Q: 10. Why is this so expensive? Is it drastically better than off-brand batteries?

A: That depends on which battery you are comparing it to. With the Atomos battery you can have confidence that the battery to perform on their products flawlessly. Other batteries may seem similar however you should consider the fact that; some batteries deteriorate faster than others (gradually decreasing battery life over time), some cheaper companies may have quality assurance problems (a kit of 2 may have 1 battery that performs better than another), and some batteries have smaller capacity (measured in Mah), While it is possible to find a battery with similar capacity and performance to the Atomos battery for less money it is safest to invest in the Atomos batteries unless you have a lot of confidence in the less expensive competitor.