This Amimon Power Cable plugs into your CONNEX Ground Unit's power port and connects to a compatible power adapter (sold separately). It's an XT-60 male to DC Plug cable that's approximately 20" long.

XT-60 Male to DC Plug    Powers Ground Unit Receiver    Approximately 20" (50 cm) Long

Related Questions and Answers

Q: 1. Can I use on sender and 4 reciver ? I need to connect 4 led screens in a concerts

A: Yes. You can connect up to 4 CONNEX receivers to one CONNEX transmitter. Video quality will not be affected and there will be no delay on all receivers.

Q: 2. If I film in 4k 60p, will it still transmit a signal to the Connexx, but just downgrade the footage to 1080p? Or will it not receive a 4k 60p signal at all? Thanks

A: I also film at 4K 60p, but my camera only sends 1080p 30p over the HDMI port which the Connex can transmit.

Q: 3. anyone know if this setup be used ground to ground with a regular hdmi output camera for remote focus capability?want to have a remote focus puller viewing camera feed.

A: Youd be better off with the Connex mini since the full sized one has a LOUD fan. Im flying a Connex Mini on a Ronin-M.

Q: 4. Does anyone know where I can source power cables for the transmitter? Would like to make some Anderson Powerpole and Anton Bauer connectors.

A: The transmitter comes with XT-60 power connector. If you purchase an XT-60 to DC jack adaptor, you'll be able to use a standard P-tap to DC jack cable

Q: 5. Where should the transmitter be powered from, separate battery, camera?

A: The Amimon Transmitter for CONNEX Mini HD Video Link for UAVs will require a 4 pin connector for use with a 8-26V 3S-6S battery.

Q: 6. can you use more then one UAV in the same physical space ?

A: The transmitter can link to up to four receivers, for example allowing the pilot and camera operator to each have their own monitor or FPV goggles (additional receivers available separately).Under optimal conditions two or three of these paired systems should have enough operating variance to function in a large outdoor, open space under optimal conditions. Be aware that we have not tested this function nor are there published specs detailing this operation. Please contact the manufacturer directly for details:USA, AMIMON INC2025 Gateway Pl. Suite 450San Jose, CA 95110Tel: 408-4904686contact@a href= http://amimon.com target= _blank amimon.com/aa href= http://www.amimon.com/contact target= _blank http://www.amimon.com/contact/a

Q: 7. Is the signal compressed to any particular bitrate?

A: Hi Nil,No, we don't compress the data and not changing the bit rate.Why do you care about that? Do you have any issue?Thanks,Yoav MalinCustomer Support manager @ Amimon

Q: 8. Does the receiver's HDMI output provide a clean video feed with no on-screen overlays?

A: There is an overlay on the bottom of the screen. It has useful info like signal strength. As far as I can tell there is no way to override this function for a clean recordable image.

Q: 9. So, 1600 get you only the transmitter? then I have to spend and other 1000 for a reciver.. ?

A: Hi, For $1599 you purchase both the transmitter (Air Unit) and the receiver (Ground unit) plus all the cables needed for their integration with the drone and camera.An extra receiver costs $999Kind regards,Netanel

Q: 10. How does this connect/mount to the ground unit? They should have photographed the back of the unit.

A: The ground unit will have the proper connections to attach this plate. It will be close the power connection as this has the proper barrel plug for the unit.