Put your binocular, spotting scope, or camera on a stable platform with Barska's Table Top Tripod. Outfitted with a standard 1/4"-20 mounting bolt on its pan/tilt head, you can lock your device in the right position with a simple twist of the handle. Its wide leg spread helps to mitigate vibrations and the slip-resistant rubber feet keep it in-place. When set up, the tripod is 10" tall, and folds to a compact 13" long to easily fit in many packs.

Compact Design    Pan/Tilt Head    Open Height: 10"    1/4"-20 Mounting Screw    Wide Leg Spread Helps Stability    Non-Slip Rubber Feet

Related Questions and Answers

Q: 1. Can I use the BlackRapid Tripod Plate 50 Quick-Release Plate (50mm) with this tripod?

A: No, this tripod head was not designed for use with Arca-Swiss products.

Q: 2. Will this tripod and ball head hold a Fuji GFX50R w/ 32-64 lens attached?

A: Should be no problem. The combined weight of the camera and lens is under 4 lbs. The tripod is rated at: Load Capacity: 8.8 lb.

Q: 3. Can i use this with my 35mm film camera?!

A: Yes, I have

Q: 4. The big knob locks both the ball and panning. So how do you actually pan on this thing?

A: These are not solutions. This is either a design flaw, a defect in my particular one, or misleading description. Load capacity is 8.8 lbs. But if you have to loosen the ball in order to pan smoothly, then the load capacity is more like a few ounces unless your camera/lens is perfectly balanced on the plate, which wouldn't be the case even with a lot of mirrorless combos.

Q: 5. Does the 3T-35R come in black?

A: Yes it does

Q: 6. which head will work best with a sony rx10 IV, this one or the 10s?

A: Any of the 3T35 series will do the job. the base model you are looking at has over an 8lb capacity. You will see that all Sirui table top tripods are very solid.

Q: 7. Hi, The ballhead can it be remove for change. Can i change it for a another one like the SBH-250DQ Aluminum Ballhead instead of SBH-100DQ ? Can i buy this kit mini tripod table-top and an another ballhead ? More robust the the 100DQ.

A: The head does come off on that tripod.It is a thread so if you do put a different head on it, you might need a tripod bushing.General Brand Tripod Reducer Bushing 3/8 to 1/4 -20B&H # GBRB Mfr # NPTRBhttp://bhpho.to/1avkNxl

Q: 8. How does one remove the bullhead and the column from the tripod? Allen wrench required?

A: The ballhead is attached using a 3/8" screw--you can remove the head by unscrewing it from the column. The column has a lock at the bottom of the tripod that can be loosened to remove the column.

Q: 9. what country is this product manufactured?

A: According to the notes in our system provided to us from Slik, this tripod is made in Thailand.

Q: 10. how good is this tri pod on a canon eos 6D w/ stigma 24mm lens?

A: I use it with my 6d MarkII with a Sigma 24 -105mm Art lens and also with my Sigma 150 to 600mm telephoto lens. I use to use it with my 1D Mark II.