The LMM1S Microphone/Line Input Module with Screw Terminal Connector from Bogen Communications is an actively balanced plug-in module designed to pre-amplify microphone inputs to line-level. It is compatible with the Vector mixer/pre-amplifier model VMIX. A mic/line switch sets the input gain range for the intended input device. Jumpers are used to select between 4 levels of priority; the LMM1S can mute lower priority modules and can be muted from higher priority modules plugged into the same VMIX. When using the module with condenser microphones, a jumper can be set for the module to supply 24V phantom power. This input module features bass & treble, gain/trim, and gate threshhold & duration controls.

Actively balanced input

Line/microphone attenuator switch

Gain, bass, and treble controls

Gating with threshold and duration

24V phantom power supply

4 priority levels

Bus assignable

Screw terminal connectors

Related Questions and Answers

Q: 1. Not going into a PA system. Will it work ok with putting a XLR connector on going into a board for talk back?

A: It should work without issues. The paging functionality it's important when you are picking up the Amp, witch is the device that attenuate the music when the pagin relay on the mic it's activated.

Q: 2. I'd like to use this to power a Senheiser MKH 416 and attach to Rode Wireless Go II to accomplish a wireless boom mic. Would this work for that purpose?

A: The Audio-Technica AT8531 In-Line Powering Module is not compatible with the Sennheiser MKH416.

Q: 3. Does this unit come with any cables please? If not, then Where in the BH photo cable finder is a cable that will work with this unit connecting an AT boundary MIC that needs phantom power please? Thanks.

A: No cables are included. The cable from the mic connects to the unit's input.

Q: 4. What is a typical application for this amplifier? Is it normally used as an audio amplifier?

A: The Bogen V150 is a mono mixer/amplifier generally used in commercial installations such as retail/office applications. It can support up to 8 input sources of various types using optional input modules and outputs to 70 volt speaker systems as well as low impedance 4 or 8 ohm applications.

Q: 5. i need specs for a tile bridge and a cover?

A: The Bogen TB-8 is the recommended accessory for the S810T725. Specs available are 8 diameter, 3 1/4 in depth. Also available with grill in bright or off white.

Q: 6. what frequency does this transmit at?thanks

A: The UBP800 is designed to work with the Bogen UDMS800 wireless mic system which operates within 470 MHz-490 MHz

Q: 7. do you have to have a special module for tel intercom?

A: thank you for your question. To connect tel intercom you would need to purchase the BH# BOTEL1S Bogen Communications TEL1S Telephone Input Module.

Q: 8. How do i convert 4 wire output to xlr

A: You can contact Bogen for a wiring diagram. You can reach Bogen by phone at 800-999-2809. Their business hours are 8:30 AM to 5:00 PM EST Monday through Friday.

Q: 9. how do I convert 4 wire output to xlr ?

A: All you will need to attach a male XLR connector to the Bogen Communications MGN19A Dynamic Omnidirectional Gooseneck Microphone is a wiring diagram for a standard 3-pin male XLR connector using 4-conductor wire. Here is an example: https://www.belcom.co.uk/technical/starquad-wiring/starquad-wiring-balanced-xlr-xlr-connections/

Q: 10. can this product be used with a hard lid ceiling?

A: Although designed for drop-ceilings. I do not see why it could not be used in a hard lid ceiling (gypsum board) installation.