Offering a 1/4"-20 mounting thread, the IndiPRO Sony L-Series Battery Adapter Plate to Sony NP-FW50 Dummy Battery is designed to attach to a cheese plate or other support on your camera rig to provide extended battery power. It allows you to use larger capacity L-series type batteries to power any camera or device that runs on a Sony NP-FW50 battery. The adapter provides a 7.4V output and features a 24" dummy battery cable.

1/4"-20 Thread for Cheese Plates, Etc.    24" Dummy Battery Cable    7.4V Output

Related Questions and Answers

Q: 1. Does Unregulated mean it will NOT protect camera during a power surge?

A: This battery is unregulated because it is specifically designed for use with the SWIT S-8845 battery, which will not output more power than this cable can handle. If you are not using this battery, we do not recommend this cable. A better choice would be the IndiPRO Tools SAFETAP to Sony NP-FW50 Regulated Dummy Battery Cable. This is a regulated cable that works with D-Tap Accessory Ports. https://bhpho.to/2Zigpnh

Q: 2. Can this be used with sigma fp ?

A: The Sigma FP would need this Sigma CN-21 instead: https://bhpho.to/2LWrgyM

Q: 3. how long is the cable from the pod to the fake battery?

A: The cable is 20 inches long.

Q: 4. What voltage are the two DC out sockets? i.e can I power a SmallHD DP4 monitor as well as the camera?

A: Yes you can power both units. Each output is 7.4 volts, you would need buy this cable to power the SmallHD DP4B&H # IN81PPC MFR # 81PPC

Q: 5. how long is this cable from battery to the dc connector?

A: The cable is 20 from the battery to the connector.

Q: 6. Is a7R IV really supported? It doesn't have a hole in the battery compartment lid

A: while the dummy battery is the appropriate fit for those cameras, the battery covers are not designed to use a dummy battery so there will be issue using this battery in the models you mentioned

Q: 7. Does this power the Sony RX100-vii?

A: Yes, this is compatible with the RX100 VII.

Q: 8. How can this be mounted? Is there a 1/4 -20 threading on this somewhere to them mount to 15mm rails? If so, can someone explain how or provide a picture so I can get a better idea of if this can fit onto my rig?

A: There is a 1/4 -20 threaded insert on the bottom of the plate for mounting on the camera or rig.

Q: 9. Does this work with Ninja V?

A: Yes it does.

Q: 10. Does the battery door remain open with this adapter?

A: More than likely yes, you will have to remove the battery door to use this dummy battery adapter.