With the Cat 6 Ethernet Cable from Hosa Technology, you can connect Ethernet-enabled devices to one another with ease. This cable comes equipped with an RJ45 connector on each end and supports bandwidth up to 550 MHz. Furthermore, this cable features a shielded twisted pair construction and is backward compatible with both Cat-5 and Cat-3 based networks.

Performance up to 550 MHz    Shielded Twisted Pair Construction    Cat 5 & Cat 3 Backward Compatible

• Performance up to 550 MHz supporting a variety of Ethernet networks
• Shielded twisted pair (S/FTP) construction for maximum EMI and RFI rejection
• Backward compatibility with Cat 5 and Cat 3 standards

Related Questions and Answers

Q: 1. can I save money by just buying two G-Tech drives and saving on both for back up? is raid 1 any more secure than two drives backing each other up?

A: the problem with doing 2 is that you have to do 2. so yes you pay more to have a single drive with internal redundancy, but that is more set it and forget it than juggling two backups

Q: 2. Can this printer use different brands of label refills?

A: The Brother QL-1110NWB Wide Format Professional Label Printer with Ethernet and Bluetooth BH #BRQL1100NWB should only be used with Brother genuine media. Using third party media can affect the results and any issues that arise from it are not covered by the warranty.

Q: 3. What is the latency? I need it for a subwoofer connection that needs to be in sync with the main speakers.

A: The Hosa IBT-402 is bluetooth 4.2, around 34ms.

Q: 4. are are there 10 ft cable?

A: No the size are only 2 inches long if you want one in 10ft there i think there's a 6ft type from Razer

Q: 5. Can this be connected to a Thunderbolt 2 port?

A: Yes, but you would need a Thunderbolt 3 to Thunderbolt 2 adapter.

Q: 6. Can you daisy these and have access to other raid configurations besides just 0,1 and JBOD?

A: Yes you can and raid 5 would also work for an OWC but no support to power a Mac.

Q: 7. what is the power source?

A: 11.30.16Thanks for asking. This is not a lamp you can use for any general purpose lighting. It is plugged in to the rear of one of our commercial lighting control consoles. The lamp is powered from the console connector, and there is a variable potentiometer on the front of the console to control the brightness. It might also be able to be used on a Yamaha CL5 or LS9-32 audio console.

Q: 8. Will this work with a Behringer X32?

A: It looks like the X32 uses a 4-pin XLR, which would be our LTE-519XLR4. Best regards, Hosa Support.

Q: 9. Does it print in color ?

A: No, this is monochrome only.

Q: 10. Can you replace or swap out the drives in the future? or if one fails?

A: Yes, it is only important that you used matched drives. The unit has currently been tested with up to 12TB drives.