These stainless steel SCREW-12S 4-40 x 1/2" Pan-Head Screws from TecNec are for mounting chassis-mount connectors in back panels and plates. They are particularly suitable for Neutrik D-series panel-mount connectors. They come 100 to a pack.

100 x 1/2" Pan-Head Screws    100 x 4-40 Nut & Star Washers    Suitable for Back-Panel Mounting

Related Questions and Answers

Q: 1. can it pan super slow for time lapse?

A: It's not possible. Slow but too fast ! or with this :http://www.jama.fr/boutique/en/shooting/remote-control/electric-3-ways-head/time-laps-1040

Q: 2. Can this unit pan and tilt at the same time?

A: Yes it will, but it would be better if it came with a joystick. I currently am looking into converting it to a Wii nunchuck and Arduino uno.

Q: 3. What is the weight of this tripod?

A: Hi, the weight of this tripod is 1.4 lbs.

Q: 4. How low to the ground does it get?

A: It goes as low as 12 inches.

Q: 5. Could I connect 2 extensions to make my reach longer? Would there be a loss of signal?

A: Hi. I have one of these units and have run two 50' extensions with it. No problems at 100'. I'm looking at ordering another one and when I get extensions for that unit I'll try to test even longer. A LANC controller for my camera also worked well at 100' with two 50' extension cables.

Q: 6. Is it possible to let it move permanently left to right and back and back and ...over an angle of 90?

A: In Auto mode it will pan back and forth at an angle of 90 degrees. You can also do it for 60 or 30 degrees.

Q: 7. Can I lock it to only do the tilt function? We don't want to hit the pan by mistake.

A: The Bescor MP-101 Motorized Pan & Tilt Head does not have a pan or tilt lock.

Q: 8. CAN THIS BE PROGRAMMED FOR STILL PHOTO PANORAMIC?

A: No, the Bescor MP-101 Pan/Tilt Head, 20' Remote Extension & AC/Battery Power Kit is fully manual and cannot be programmed whatsoever.

Q: 9. What cable connector is used on the MP-101? I'd like to use an Arduino to control the pan and tilt. I do not want to cut up the cable to do this.

A: Greetings, Joe. I think I understand your intention but I'm not sure you can achieve it with the Bescor MP-101. To confirm, the unit uses a 7-pin (female) DIN connector to support its wired remote equipped with a 7-pin (male) DIN connector. The seven pins are required to allow the MP-101 to pan, tilt and (in combination) move diagonally. It looks like the Arduino uses a bayonet-style mount that probably has only a signal and ground connection. How you'd adapt that to provide full Bescor functionality is uncertain. If you want to experiment, Bescor sells a 25' extension cable with 7-pin M/F DIN connectors on the ends and you could cut that up to work on wiring options. An alternative would be to consider using a Camranger wireless WiFi controller instead. It works with both the MP-101 as well as Camranger's branded equivalent and provides full wireless motion control using a proprietary app on your smart device. That solution has performed very well for me. You might want to check it out!

Q: 10. Can this unit be used with non digital audio signal?

A: It cannot AES/EBU Digital Audio only.