The Connector Cable from 2N allows you to connect your 2N Access Unit to a LAN via RJ45 Ethernet.

Connects Access Unit to LAN    RJ45 Connector

Related Questions and Answers

Q: 1. Is this compatible with the Canon EOS R5? It's not listed but the R6 is. Didn't want to assume.

A: Vello 3.5mm Remote Shutter Release Cable II for Canon Sub-Mini won't work with the R5 because the R5 uses the Canon 3 pin connector. You can use this one that is 3 pin. https://www.bhphotovideo.com/c/product/1629686-REG/vello_rcc2_c2_35_3_5mm_shutter_release_cable.html

Q: 2. SmallRig battery

A: The Lentequip SafeTap Connector will work with any Battery brand that has a D-TAP/P-TAP connector on the battery. Assembly info: https://bit.ly/47J2JDP

Q: 3. I have a Canon ZSG-200m grip that has the standard 8 pin male connector. Will this cable work with the new Canon 20pin ports on the CJ series ENG/EFP lens?

A: Yes, the following cable will work for the Canon CJ18EX7.6B IASE 2/3" ENG/EFP lens. If a extension cable is needed please look into the following cable. ​ https://bhpho.to/3ytR6i

Q: 4. Does this work with the Canon C200?

A: Yes, this should work with the C200 as well. The C200 comes with the UN-5 cable, which is around half the length of the UN-10.

Q: 5. Does this work with the C500 MK II?

A: Yes it does. This cable is even included in the box with the C500 Mark II.

Q: 6. Is this the same cable already used to connect the C300mkii monitor to the body?

A: Yes it is!

Q: 7. Does it work with C500 m2?

A: Yes it does.

Q: 8. Is this the same cable that's used for the C300 Mark I?

A: According to Canon's documentation, the Canon UN-5 Unit Cable, is only compatible with the following models: "Canon C200, C300 Mark II/III, C500 Mark II, C700, and XC15".

Q: 9. I am looking for a cable to connect the Nikon D70 to my Vello Shutterboss unit for taking time lapse sequences. Any suggestions?

A: Unfortunately the Nikon D70 does not accept a wired remote such as the Vello Shutterboss. It only works with an infrared wireless remote as shown in this link. https://www.nikonimgsupport.com/na/NSG_article?articleNo=000026486&configured=1&lang=en_SG

Q: 10. Will this work with the c200B if I plan to buy the LCD separate? There really isn't any info about how to get a connection cable if you want to buy the B version...it looks like UN-5 is what is listed on the spec sheet for the full model so I was wondering if this cable will work. Thanks

A: This is the correct cable for the Canon LM-V1 4 LCD Monitor for C200 and C200B.