Manage your 19" rack installation with ease by including the ATTO FlexRack Rail Kit. Installing this rail kit onto your separately purchased FlexRack Rackmount Shelf allows it to slide out. Use it to quickly organize or troubleshoot your ThunderLink and XstreamCORE adapter configurations, manage power supplies, and more.

For ATTO FlexRack Rackmount Shelf    Fits 19" Racks    Sliding Rail Kit

Related Questions and Answers

Q: 1. Does it have to be mounted on a tripod or can it be placed and lay flat on a table top for use?

A: It can be used on a flat table top but will likely topple when the camera is too far forward. A tripod or table-top tripod would be best to keep it grounded and hold it in place, but depending on how you plan on using it, that might be optional.

Q: 2. Hello,Does this work with Bogen 488RC2?Thank you for checking.

A: Yes, you can use this with the Bogen 488RC2.

Q: 3. With a 100mm macro on a canon 1d, can it handle the weight?

A: Yes, it will hold weight of the 1D and the 100mm macro.

Q: 4. Can the top plate (ARCA) be turned 90 degrees to support lens mount foot?

A: I contacted Oben Gear concerning your inquiry. According to the manufacturer, they state that "Unfortunately, you are not able to turn the quick release on this 90°; the reason being is the notches on the bottom are a bit to short going the other way, so they don’t fully match the protruding part on the head."

Q: 5. The top rail, which I think is for side to side movement, makes a clack sound for every turn of the knob. The sound happens for one way only.Is this normal? Is there a way to stop it?

A: The top rail is for forward/back movements and while I don't get the clack sound you mention it is definitely is not as smooth as the bottom rail which is for side to side movements. This is due to the different gear mechanisms used for each, I think it would be a better focusing rail if they had used the same gear on the top rail as the the bottom as it is butter smooth. What I did find with mine is that the end apps that hold the rails in position were loose and nothing on the tool they provide will tighten them.

Q: 6. Is the maximum load really 1.6 pounds as stated in the manual? That would be only for compact cameras, wouldn't it?

A: This is an error; there isn't really any maximum load capacity on this macro rail. The manuals are reprinted and our website will be updated shortly.

Q: 7. Can I mount this on my Manfrotto XPro 3-way head?

A: Since this rail has a 1/4-20 thread at the bottom, you can attach it to a head like a Manfrotto XPro 3 way head.

Q: 8. If I already have camera specific Markins quick release plates on my cameras can I just set the included that off to the side?

A: Markins quick-release Arca-Type compatible plates are compatible with the Oben GH3W-15 3-Way Geared Head.

Q: 9. will this fit a 410 jr. gear head?

A: It will work with a 1/4-20, or 3/8-16 thread mounting screw on the underside, and it comes with an Arca-Swiss type plate on the top with a 1/4-20 threaded mounting screw. This should adapt to most any standard mounting setup.

Q: 10. This rail can be mounted on a common tripod screw?

A: Yes.