Mount a computer under your desk and swivel it around for easy access to ports and cables with the Under-Desk CPU Holder from Uncaged Ergonomics. This neutral gray steel mount attaches under a wooden desktop using a four-point mounting system, and it lets you swivel your CPU up to 360° as well as slide it in and out from under your desk. Ideal for standing desks, the mount's adjustable height and width is designed to fit most computer cases.

Mount a CPU under your Desk    Swivels 360° and Slides In & Out    Allows for Easy Access to Ports & Cables    4-Point Mounting System    Adjustable Height and Width

Related Questions and Answers

Q: 1. Will this work on a Manfrotto 498RC2 ball head?THANKS

A: yes

Q: 2. Is it possible to attach a ring light?

A: The Slik Sliding Arm II has a standard 1/4"-20 head mounting screw. If the ring light has a 1/4"-20 socket it will mount. If the ring light has a different mount you will need an adapter.

Q: 3. Will it fit the Impact Deluxe Varipole Support System?

A: Unfortunately, no, the Impact Sliding Arm Support with Hand Grip is not compatible for use with the Impact Deluxe Varipole Support System. It is only compatible for use with the Impact Column Stand. The Impact Column Stand has a uniform tubing diameter of 1.38” (35mm), while the Autopoles and Varipoles have a larger tubing diameter of (bottom) 1.77” (45.4mm) & (top) - 1.58” (40mm). They are not compatible or interchangeable with one another.

Q: 4. How high does the sliding arm go up without the top pole (so it's not 8 feet tall) ?

A: The sections of the column would be less than 50".

Q: 5. Will this fit a Mathew's c stand?

A: The Impact Sliding Arm Support with Hand Grip will not fit the column on a Matthews C-Stand.

Q: 6. I have this stand. I just realized that the 2 top poles are supposed to be locked or secured together somehow. I see holes for screws but nothing inside them. Any ideas??

A: There is only a hex screw which allows the two sections to fasten together. The hole at the top portion would not need a screw.

Q: 7. Hi I just got this stand in and was very disappointed because the stand is too tall! Im assuming I just fit the pieces together right?

A: Yes. The vertical pole is designed with 2 pieces but the upper pole section isn't required to use the stand. I also have a problem with the upper pole installed as it's too tall for my studio ceiling. However, in my circumstance, by leaving the upper pole off, the vertical adjustment with just the lower pole is all that I need due to the size of my softboxes. I have read where others have used a metal hack-saw to cut the upper pole to an acceptable height based on their requirements.

Q: 8. What is the diameter of the boom section? Thanks!

A: Slik does not list the diameter of the Slik Sliding Arm II. But it is approxemelty an 1-1.5 inches.

Q: 9. Complaints about play in the early rails. Has that been corrected in later products?

A: The aren't any issues with the latest stock.

Q: 10. Will this hold a Bowens Gemini 500 monolight with a soft box ?

A: No. It will hold the monolight with no problem but using a softbox will cause it tip with the slightest movement, unless some weight is placed on the opposite leg. Also, there is not much clearance to adjust the angle of the softbox. It is an awesome stand for a single light. I have 2 of them and one I use as a camera tripod when shooting in studio. The pistol grip allows for very quick adjustments.