Upgrade your SureFire M600 Scout Light with the black KM2 Infrared & White Light Conversion Head. Mounted on the Scout Light body, this head will deliver 2.5 hours of 350-lumen white light or 16.8 hours of IR illumination on two CR123A batteries. Switching between white and IR is as easy as twisting the head—no filter to attach or remove. Made of durable hard anodized aluminum with a Total Internal Reflection (TIR) lens, the light head weighs just 1.3 ounces and won't weigh your weapon down.

Upgrades M600 Scout Light    350 Lumens of White Light    120mW Infrared Light    Twist Head to Select Light Mode    Runtime: 2.5 Hours White, 16.8 Hours IR    Total Internal Reflection (TIR) Lens    Hard Anodized Aluminum Housing

• Compatible with SureFire M600 Scout Light
• 350 lumens of white light (2.5-hour runtime)
• 120mW Infrared light (16.8-hour runtime)
• Total Internal Reflection (TIR) lens for long throw with ample surrounding light
• Hard anodized aluminum housing

Related Questions and Answers

Q: 1. Does this light screw into a HK or Surefire foregrip for an MP 5

A: It's for a SureFire LM2 6 VDC LED Conversion Head for 600 & 900 Series Forend Lights.

Q: 2. Will the outcome with a Lee #87 be comparable to a screw on r72 filter (Lee better with multiple lenses)?

A: Yes, I believe the 72 filter is just as good to use as the 87 filter. I hope that helps.

Q: 3. Is the X100 II Tele lens weather resistant?

A: Yes. This lens is weather sealed.

Q: 4. what's the developing time for this film using Kodak X-tol developer, I used hoya R72 filter

A: I don't know the effective reduction of your filter, but for an effective ASA of 50 a 1+1 dilution at 20 degrees C and a time of 7 1/2 minutes should suffice.

Q: 5. Given that this film is less sensitive to IR light than visible light, what ASA should it be shot at for infrared photography?

A: It depends on the filter you use with the Rollei Infrared 400 Black and White Negative Film (35mm Roll Film, 36 Exposures). Some say, exposing the film at a maximum of ISO 25 and using an R72 dark red infrared filter or deeper infrared filter. Note it takes experimentation and trial and error

Q: 6. I am thinking on upgrading to this from my older module, my question is, can i get any kind of switching tailcap for the leftover module if i upgrade?

A: Unfortunately there is no accessory tail cap available.

Q: 7. Can this film be developed in Ilford ILFOTEC DD-X Developer?What is the developing time using the Ilford ILFOTEC DD-X Developer? any recomendations?

A: Hi Ali,So far I have only used Kodak D-76 (1:1), I have been delighted with my results..I don't know if ILFOTEC DD-X compares with D-76.Good Luck enjoy the Film!!!

Q: 8. Is this film useable with a B+W 093 IR filter? What ISO would I set on my meter?

A: Yes you can use the B+W -93 IR filter with Rollei Infrared 400 Black and White Negative Film (120 Roll Film, Boxed). Note, results can vary.

Q: 9. How would exposure & auto-metering be affected if used with a 720 nm filter over a flash head?

A: The exposure would be cut down by quite a bit. It doesn't make sense to shoot in auto. You will have to shoot in manual mode and test by trial and error

Q: 10. Does it reduces the camera's max aperture? Similar to how Canon extenders reduce the aperture by 1 or 2 stops

A: Works at f/2 and f/16 without issues. Love the lens!