The Audio-Technica Consumer AT-VMN95SP is a 3 mils conical replacement stylus for the AT-VM95SP dual moving magnet cartridge. The bonded round shank utilizes an aluminum pipe cantilever.

The conical stylus has a spherical tip, which normally touches the center of the record groove walls. This design is well suited for older players with higher tonearm tracking forces.

For AT-VM95SP    Dual Moving Magnet Cartridge    Conical Stylus

Related Questions and Answers

Q: 1. I asked a question - here it is again. Can this be used with any 46 umbrella, or does it have special connectors?

A: Assuming you do have a 46-inch umbrella, this diffuser should work. It attaches by fitting the ends of your umbrella's ribs through holes along the diffuser perimeter. You may want to affix gaffer tape or Velcro in a spot or two to make it extra secure.

Q: 2. How long is this foot?

A: The foot is 5.5" x 1.5" x 1.5".

Q: 3. How do you know if you need to replace the light (tube) my firing is getting less consistent. Or will the thing just stop working all together? It's pretty pricey and I don't want to have to buy a new one if this isn't the case.

A: The flash tube needs to be replaced when you are getting no flash out of the Profoto head. Tubes can easily be replaced by a plug and play procedure.

Q: 4. Will this work with the Z 70-200 f2.8?

A: No, this Sunwayfoto Replacement Foot is only for the NIKKOR 70-200mm f/2.8G ED VR II Lens.

Q: 5. Is the 40.5mm threaded end male or female?

A: The Novagrade 40.5mm Digiscoping Adapter for Select Olympus Stylus TOUGH TG-Series Digital Cameras has 40.5mm male threading to mount on cameras or adapters with 40.5mm front threads. For use with the Olympus Stylus TOUGH cameras you would need the separately-available Olympus CLA-T01 Conversion Lens Adapter on the camera, BH #OLCLAT01 (https://bhpho.to/3xrKvHF).

Q: 6. I have the Sunwayfoto Arca & Manfrotto Compatible Clamp (MAC-14). Is the Sunwayfoto Replacement Foot for Nikon 70-200mm the best option?

A: Yes, for the cost, it would be the best option.

Q: 7. Where can I get a replacement screw? ...... the one that holds the blade...I dropped mine and unfortunately have not found it in my craft room.

A: B&H unfortunately does not stock this replacement part. Please contact the manufacturer directly. a href= http://logangraphicsinc.com target= _blank logangraphicsinc.com/a

Q: 8. Will this foot fit to the older 300mm f2.8, non IS from the 1990's?

A: The Naturescapes CLF-300 is designed to fit the Canon EF300mm f2.8L IS II and Canon 400 f4.0 DO II lenses. It was not designed for use with the older Canon 300mm lens, and as the lens has been discontinued and is no longer available for purchase, there is no way to test the replacement foot on the lens. However, the manufacturer does state that the replacement foot may fit other lenses not listed, so there is a possibility it may work on your lens. You would have to test it and see. If it does not work, do note you have 30 days from the date of purchase to return the replacement foot for an exchange or a refund.

Q: 9. Will this work on a Nikon 70-200 F2.8 vrii lens?

A: Yes, the Sunwayfoto Replacement Foot for Nikon 70-200mm Lens would work with the AF-S NIKKOR 70-200mm f/2.8 VR II Lens.

Q: 10. Will this fit on the canon rf400 2.8?

A: The CLF456 is not compatible with the Canon RF 400mm f/2.8L lens.