The 3/8"-16 Female to 1/4"-20 Male Tripod Thread Reducer from CAMVATE enables you to mount a camera, tripod head, or other accessory with a 1/4"-20 thread onto a tripod or other support with a 3/8"-16 screw. A non-slip rubber gasket is included with this adapter.

3/8"-16 Female to 1/4"-20 Male Adapter    Non-Slip Rubber Gasket    Nickel-Plated Brass Construction

Related Questions and Answers

Q: 1. Is it strong enough at full length ?

A: Yes. The following unit will support 14.3 payload.

Q: 2. Does this convert to a Monopod? Can it handle Nikkor D750 with 200_500 lens?

A: I don't think it will convert to a monopod.A long lens could work on a 200 to 500 depending on where the mount bracket is. I have a Tokina 150- 500 that I use on a monopod most of the time for sports action it has the mount in the middle and is well balanced

Q: 3. How do you change between the 3/8 and 1/4 inch studs?

A: You will need a 1/4"-20 to 3/8"-16 bushing. https://www.bhphotovideo.com/c/search?Ntt=bushing&N=0&InitialSearch=yes&sts=ma

Q: 4. Will it hold an iphone 11Pro in a Otter case? It's the thickness of the case I'm concerned about. Thanks

A: It may accommodate your phone with the Ottercase but it would just barely fit.

Q: 5. Would this unit work with a Zhiyun Weebill-S? Is it compatible?

A: Yes

Q: 6. Does it rotate so the phone can be turned both vertical and horizontal?

A: The Oben mount does provide the ability to flip the phone to Portrait or Landscape.

Q: 7. does this fit a samsung phone?

A: The Oben ASPTA-20 Smartphone Tripod AdapterBH #OBASPTA20 fits smartphones that are 2.4 to 3.7" / 6.1 to 9.4 cm wide. If your phone meets those requirements, it will work.

Q: 8. How far apart are the two 1/4" holes?

A: I'm very sorry but Oben does not specify how far apart the two 1/4'' holes are on the Oben ASPTA-20 Smartphone Tripod Adapter BH #OBASPTA20.

Q: 9. 14.3 lbs on a 1/4" - 20 ?? Am I the only one who doesn't trust this tiny screw to support a moving camera rig (under stress)? Engineers please weigh in and reassure me.

A: If your camera/device has a 1/4-20, this will handle it. If you look up the tensile strength of 1/4"-20 bolts, you will see figures that are greater than what you can lift.

Q: 10. I know this is a silly question but I do not want to accidently damage this unit. What is the correct way to remove the rubber pad on the bottom to expose the hole for the feet?

A: This should only be a protection cap for travel and should be easy to remove.