The PFL-XT3 Custom L-Bracket for FUJIFILM X-T3 from Sunwayfoto is a single-piece design that is CNC machined from T6061 aluminum with a Type-III hard-anodized finish for durability. The Arca-type L-bracket can mount in both a vertical or horizontal orientation, and dual safety stops are located on the bottom of each axis as a precaution against the L-bracket from sliding out if the quick release clamp is partially opened by accident.

The camera mounts to the bracket via a 1/4"-20 male threaded screw, and an anti-twist lip and an alignment pin on the plate prevent and minimize any movement between the camera and the bracket. The camera's ports are completely accessible including the battery chamber, and the tilting and rotating LCD screen is not blocked.

Single-Piece Design    Arca-Type Compatible    Mounts Vertically and Horizontally    CNC Machined T6061 Aluminum    Type-III Hard-Anodized Finish    Anti-Twist Flange, Alignment Pin    Maintains Camera Port and Battery Access    No Blocking of the Rotating LCD Screen    Safety Stops on Both Axes

Single-piece design with Arca-type dovetails, which allow the bracket to mount in a vertical or horizontal orientation

CNC machined T6061 aluminum with a Type-III hard-anodized finish for durability

An anti-twist flange and alignment pin on the plate prevent and minimize any movement between the camera and the bracket

The bracket maintains camera port and battery access and also does not block the tilting and rotation of the LCD screen

Dual safety stops are located on the bottom of the bracket on each axis, which prevents the L-bracket from accidentally sliding out of the quick release clamp

Related Questions and Answers

Q: 1. Does this bracket have a 1/4 20 threaded hole on the bottom for attaching custom plates like a Peak Designs capture plate?

A: Yes, it has a 1/4-20 thread on bottom.

Q: 2. Where are the included rubber washers supposed to go?

A: The rubber washers are there to protect the threading on the screws.

Q: 3. I don't see any plastic pads on the bottom of the L-Bracket to protect from scratches. Does it scratch the bottom of the camera?

A: No, if the bracket is correctly mounted to the camera, it will not scratch the camera.

Q: 4. Is this compatible with the R5 mark II?

A: Unfortunately no. The dimensions of 2 cameras are slightly different so new L-Brackets will need to be made for the Mark 2 version. So the Sunwayfoto Custom L-Bracket for Canon EOS R5 & R6 will not fit the R5 Mark 2.

Q: 5. Is the additional hole on the bottom a 1/4 20?

A: Yes, the PFL-XT3 L-Bracket does have an additional 1/4-20" thread on the bottom.

Q: 6. Does it scratch the bottom of your camera?

A: This bracket would not scratch the bottom of the X-T3.

Q: 7. Does this bracket fit the canon EOS R5?

A: No, only for the EOS R.

Q: 8. Is it easy to reach to the LCD notch to change angle while it's on the camera?

A: Yes.

Q: 9. Will this work with the extension grip?

A: Unfortunately, no.

Q: 10. Does this bracket allow full unimpeded use of the articulating rear view screen while attached to the RP camera?

A: Yes, you can articulate, open and closed the Canon EOS RP LCD using the Sunwayfoto Custom L-Bracket for Canon EOS RP Mirrorless Camera. The antitwist bar on the bracket allow full articulation and access to all camera ports.