The Anti-Tip Bracket Kit from Dana Dolly protects your camera gear by helping to prevent the Dana Dolly platform from tipping off of the track. It includes two anti-tip brackets that attach to either side of the dolly platform that catch the track rail if the platform begins to tip. Also included is a center support for longer track runs. Rather than the rail clamps found on the standard center support, this center support features felt lining and freely rests underneath the track. The low-profile design allows for dolly platform clearance when the anti-tip brackets are attached.

Prevents Dana Dolly Tipping Off Rails    Two Anti-Tip Brackets    Low-Profile Center Support    Made in USA

Related Questions and Answers

Q: 1. Can I use this with the Sachtler Aktiv head adapter? I want to use it with my Aktiv8 head.

A: Dana Dolly makes an adapter for the Sachtler aktiv6, 8, 8T, and 10. Dana Dolly 75mm Adapter for Sachtler aktiv6, 8 & 8T https://www.bhphotovideo.com/c/product/1682567-REG/dana_dolly_ddaktiv75adp_75mm_adapter_for_sachtler.html Dana Dolly 100mm Adapter for Sachtler aktiv10 https://www.bhphotovideo.com/c/product/1682566-REG/dana_dolly_ddaktiv100adp_100mm_adapter_for_sachtler.html

Q: 2. What is the distance between the center of each pipe? Trying to figure out how wide it is. Want to run it through a car window.

A: The track width on centers for the Dana Dolly Universal Track End Bracket is 300mm.

Q: 3. Is it a way to make the bubble lever adjustment with a fluid head on this riser? Do we need another piece of equipment?

A: The hi-hat sits in-between your ball base and your head. Generally the sticks or the head has a bubble level to make these adjustments.

Q: 4. 9' might be a little long for what I need. Is there a way to shorten it?

A: The track kit comes in sections, so use 1 section only.

Q: 5. What is the track width that these brackets provide?

A: The track width is 12 .

Q: 6. What is the load capacity of this motor?

A: Kessler doesn't provide a load capacity for the motors on the Kessler Crane Motor Kit for Dana Dolly. The payload has more bearing on the type of track you have and the support for such and the payload above.

Q: 7. Does this product only come with only one track end? or does it come with a pair?

A: The Dana Dolly Universal Track End Bracket (B&H# DADDUTE1) is a single track end bracket and not a pair.

Q: 8. Can you mount this 'unslung' on the bottom side of the Dana dolly as is, or are there other bits you'd need?

A: Just as is

Q: 9. Is there a version of this with a flight case?

A: We think you are thinking of these dollies. However, in order for them to fit in a reasonable case, they do not incorporate a high hat. https://bhpho.to/2kitBVS

Q: 10. Does this include a motor? Is it compatible with Kessler's Drag Module (BH #KECS1107)? I am trying to add more drag to a Dana Dolly.

A: Yes. The kit includes the following. Motor Pod & Hardware Belt Clamps (set of 2) Length of belt selected 6' Cat5 Cable The following unit is compatible with dana dolly original & universal track ends.