The RE3-ACC-RMK1 Rack Mount Kit for a Single RE3 Receiver from Electro-Voice mounts a single RE3-RX receiver into a 19" rack. It firmly secures the wireless receiver in the rack and includes two rack ears, two 50-Ohm cables, two plastic hole plugs, four mounting screws to mount the stock receivers, 1/2 wave antennas, or coax extension cables for remote antenna applications.

Securely Mounts Single RE3-RX Receiver    For 19" Rack    Includes 2 Rack Ears    2 Front-Mount Antenna Cables    2 Plastic Hole Plugs    4 Mounting Screws

Equips single RE3 receiver for rack mounting

Provides front mounting of antennas or cables

Two high-quality RG-58 50-Ohm front-mount cables

Includes rack ears, cables, mounting screws, and hole plugs

Related Questions and Answers

Q: 1. Is this compatible with the Nikon D4s?

A: yes

Q: 2. Does this camera cable trigger the Nikon DSLR D800 and D750 ?

A: The Nikon D800 and D810 (which I have) have the previous standard 10-pin connector port for cable release and remote shutter capability. The D7100 and D750 are the new models that no longer have the 10-pin connector, which has been replaced with the MCDC2 connector port. This Pocket Wizard Cable is a great cable for this connector for using remote capability and trigger release. Good length. Good quality. In other words the D800 and D750 require 2 different cables. A 10-pin connector cable for the D800; The N-MCDC2-ACC-1 Pocket Wizard Cable for the D750.

Q: 3. how do you remove cable from the camera?

A: Simply remove the cable by pulling it, much like removing a plug from a socket.

Q: 4. Would this be able to hold 3 13' light stands with some accessories? I know the length makes it by an inch.

A: The interior dimensions are: 46 x 10.5 x 10.5 (116.8 x 26.7 x 26.7cm) (HxWxD) So, Trevor, as long as the light stands are less than 46 long when closed, and if they arent too wide when closed to fit into a 10.5 x 10.5 compartment, then the case should work for you.

Q: 5. I didn't see any pictures in the customers photos of people being able to fit the base of a C-Stand in here, will it fit?

A: Depends on the size of the C stand. I use it mostly for my lighting.

Q: 6. Does this connect to the Nikon D850

A: This cable is compatible with the Nikon D850 via the 10 pin remote connection.

Q: 7. Will this work with Olympus EM1X?

A: Yes, according to Olympus' website, it is compatible with the EM1X.

Q: 8. Will this work with Canon 90D?

A: yes it does , to trigger the camera

Q: 9. Can I use this with the PocketWizard Plus II?

A: Yes. Note: The CM-N3-P is an older cable that has been replaced by the CM-N3-ACC combined with the PTMM to allow you to pre trigger your camera. The CM-N3-ACC is for Canon cameras with the N3 connection. The PTMM can connect to any -ACC PocketWizard cable to give a pre trigger function.

Q: 10. Is it compatible with Canon 5D Mark IV? This model is missing in the compatibility list.

A: Yes, this PocketWizard CM-N3-ACC-1 Remote Camera Cable with PTMM Pre-Trigger Adapter Kit (1') is compatible with any Canon with the Canon 3 pin N3 connection, including the 5D Mark IV, 1DX Mark II, 1DX Mark III, EOS R5, and EOS R3.