The RE3-ACC-ALPA Active Log Periodic Antenna from Electro-Voice is an active directional antenna with switchable 3 or 10 dB of amplified gain. It can be used to increase desired RF signals while rejecting unwanted RF signals when paired with an Electro-Voice wireless receiver and low-loss coax cables (sold separately). The RE3-ACC-ALPA active antenna mounts on a standard threaded microphone stand for easy placement.

Active UHF Directional Antenna    Extends Wireless System Range    470-960 MHz Frequency Range    Switchable 3 / 10 dB Active Gain    BNC Connector    Mounts on Standard Microphone Stand

Related Questions and Answers

Q: 1. Will this work with Canon 90D?

A: yes it does , to trigger the camera

Q: 2. Does the 3.5mm male have 3 or 4 sections? I want to use on the Lacerta GenII controller. Thanks

A: The 3.5mm connection point on the PocketWizard N-MCDC2-ACC-1 Remote Camera Cable (1') has 3 sections. This would be considered a TRS connection.

Q: 3. Will this antenna work for range G 566-608? And both receiver and transmitter?

A: Yes. The Sennheiser 578854 Antenna can be used with SK 100/300/500 and SK 2000 Bodypack Transmitters from the G2, G3, and G4 series that operate on any frequency band between 558 to 626 MHz.

Q: 4. how do you remove cable from the camera?

A: Simply remove the cable by pulling it, much like removing a plug from a socket.

Q: 5. this ítem come come un a pack of two?

A: This is a single antenna.

Q: 6. Can this perform like a half shutter press?

A: If you are using a Plus III as a transmitter, yes, it can. A MultiMAX with an -ACC port can also pre trigger your camera. If you add a PTMM adapter, you can keep half press constantly turned on with any PocketWizard.

Q: 7. how many different users can connect with this to screen share to a large monitor in conference room?

A: The number of simultaneous users is not documented. Could be unlimited or at least dozens depending upon the available bandwith. "Unlimited Users. Any Content. Any Device. Any Operating System ScreenBeam 960 uses a secure, high performance, network-efficient peer-to-peer streaming technology to enable wireless content sharing. The ScreenBeam 960 eliminates the constraints of cables and adapters so users can drive content from anywhere in the room and can wirelessly collaborate."

Q: 8. I can't unplug it from the side of the camera. Is there a trick to disconnect it? I really apreciate any help. Thank You!

A: Hold the outside of the portion that is pluged into the camera (silver looking) and pull straight out.

Q: 9. will this antenna work with the EK 100 G2 A receiver with the same frequency 518-554mhz?

A: Replaced the antenna on my G2 and it works great!

Q: 10. Does this antenna work with my Sk/Ek 100 (516-558 frequency)? Thanks for your reply

A: This antenna only works in 558 to 626 MHz