The RE3-ACC-PLPA Passive Log Periodic Antenna from Electro-Voice is a passive directional antenna with 10 dB of passive gain. It can be used to increase desired RF signals while rejecting unwanted RF signals when paired with an Electro-Voice wireless receivers and low-loss coax cables (sold separately). The RE3-ACC-PLPA passive antenna mounts on a standard threaded microphone stand for easy placement.

Passive UHF Directional Antenna    470 to 960 MHz Frequency Range    Extends System Range    10 dB Passive Gain    BNC Connector    Mounts on Standard Microphone Stand

Related Questions and Answers

Q: 1. Can this perform like a half shutter press?

A: If you are using a Plus III as a transmitter, yes, it can. A MultiMAX with an -ACC port can also pre trigger your camera. If you add a PTMM adapter, you can keep half press constantly turned on with any PocketWizard.

Q: 2. Does this work with the canon R3?

A: The PocketWizard CM-N3-ACC Canon 3' Remote Camera Cable will connect to the Canon R3 camera.

Q: 3. Does this cable work with the 1DX MKii?

A: The 1D X Mark II uses the N3 connector so you are good to go.

Q: 4. Does this camera cable trigger the Nikon DSLR D800 and D750 ?

A: The Nikon D800 and D810 (which I have) have the previous standard 10-pin connector port for cable release and remote shutter capability. The D7100 and D750 are the new models that no longer have the 10-pin connector, which has been replaced with the MCDC2 connector port. This Pocket Wizard Cable is a great cable for this connector for using remote capability and trigger release. Good length. Good quality. In other words the D800 and D750 require 2 different cables. A 10-pin connector cable for the D800; The N-MCDC2-ACC-1 Pocket Wizard Cable for the D750.

Q: 5. Will this work with Olympus EM1X?

A: Yes, according to Olympus' website, it is compatible with the EM1X.

Q: 6. Hello. Is possible to buy only Glide Gear SYL-960 Floor/Track hybrid, without the Tripod Dolly?

A: I don't know !

Q: 7. I know it works with the newer Pocketwizards, but will it also work with older Pocketwizard Plus II triggers?

A: Yes, depending on camera make and model for more support please contact our live chat team.

Q: 8. how many different users can connect with this to screen share to a large monitor in conference room?

A: The number of simultaneous users is not documented. Could be unlimited or at least dozens depending upon the available bandwith. "Unlimited Users. Any Content. Any Device. Any Operating System ScreenBeam 960 uses a secure, high performance, network-efficient peer-to-peer streaming technology to enable wireless content sharing. The ScreenBeam 960 eliminates the constraints of cables and adapters so users can drive content from anywhere in the room and can wirelessly collaborate."

Q: 9. Is this works on Nikon D810 with Pocket wizard FlexTT5 Transceiver with AC3 zone controller?. I want to trigger from Nikon D810 mounted with PW FlexTT5 to two Nikon D610 which is also connected via Pocket wizard FlexTT5. Want use AC3 zone controller so I can select which camera to take 2nd shot.

A: I hadn't though of that but I did a quick test and the camera triggering port seems to ignore the zones. You could program two channels and switch from C1 to C2 to fire different cameras. This was a very basic test, and that is what I saw.

Q: 10. this ítem come come un a pack of two?

A: This is a single antenna.