The Telescopic Baby Stand Extension from Kupo is used to extend light stands or booms by 15.8 to 24". Equipped with a 5/8" Baby pin, this stand is ideal for use with a variety of studio equipment including lights, grip heads, and other gear compatible with a 5/8" receiver.

Maximum Extension: 24"    Minimum Extension: 15.8"    Extend Equipment with 5/8" Receiver    Solid Chrome Steel Construction    Knurled Neck Design Prevents Slippage

Related Questions and Answers

Q: 1. Does this affect the payload capacity of a stand since it increases the height? I.e. if the max payload is 5kg for a stand

A: This would depend on the stand this is being used on. If we are using a strong stand such as a C Stand or Stronger like a Combo Stand then this extension would have no affect on Load Capacity. However if we are using a simple aluminum stand which already has a low Load Capacity of 5kg then it would affect the overall Payload of the stand. It would cause the payload to sway which may cause the stand to tip over. If you need the extra height then it would be better to use a lower payload than what the stand was rated for or use Sand Bags on the bottom of the stand to increase stability.

Q: 2. How much weight can it hold?

A: The following unit is rated for 15lbs safely.

Q: 3. How much weight could this hold if i decide to use this as a boom arm?

A: This extension is not recommended for use as a boom arm, therefore the manufacturer would not offer a load capacity in this case. Matthews does offer the Matthews Baby Boom, B&H # MABBM which can fit light stands with a 5/8" pin, specifically C-stands or roller stands. https://bhpho.to/2ZCoRhS

Q: 4. Why is it called baby ? - makes it sound like it's smaller than a standard light stand - will it only work with baby stands?

A: Baby refers to the size of the mounting post atop the stand and not the size of the stand. It's the most common size used on photographic light stands. The next size up is junior which is quite a bit larger and made for heavy light fixtures. So yes, this extension will only attach to a stand with a baby post.

Q: 5. Does the fixed 5/8 stud have internal threads on the end and what are they?

A: No, the 5/8 stud on the top of the Matthews Telescopic Baby Stand Extension does not have threads.

Q: 6. Can I use this with the Matthews Reverse Stand - 7' (2.1m) ?

A: Yes, the Matthews Telescopic Baby Stand Extension will work on the Matthews Reverse Stand.

Q: 7. Can I put a 5/8' spigot at the top of the extension?

A: Yes.

Q: 8. Is it correct that the minimum working height and collapsed height is: 1cm as stated in the specifications?

A: The working height is 41" or 104cm.

Q: 9. are there are some other similar options?

A: There is this one that is like but not exactly like the Kupo Baby 5/8" Side Arm (Chrome-plated), Matthews Heavy Duty Baby Side Arm, BH #MASABHD • MFR #429752, https://bhpho.to/3cQWhnv

Q: 10. I am looking for something like this but with a baby plate to mount to the ceiling instead of mounting two parts with a separate baby plate. Do you sell any telescopic extensions with baby plate?

A: If looking to bolt the plate into the ceiling, you may only do so by using a separate baby plate like the Matthews Baby Plate - 3 B&H # MABP3 with this extension.