The Q7-ACCW Mini Wireless Microphone System for Accordion from AMT includes two Q7 transmitters, an AMT ACCR (right hand) microphone, an ACCL (left hand) microphone, and two AMT Q7 Mini receivers that are small enough to fit in an instrument case or travel bag. They operate in the 900 MHz frequency range and can be used to capture audio for accordion in live stage, theater, recording, and rehearsal applications.

The receivers are powered by standard 12V power supplies, or for quicker and more portable setups, they can be powered by AA batteries. The Q7 transmitters are each powered by a single AA battery. The antennas are permanently attached to make set up easy. This system offers 100 preset selectable channels and syncs with the Q7 transmitters via infrared.

2 x AMT Q7 Mini Receivers    2 x Q7 Clip-On Transmitters    AMT ACCR and ACCL Microphones    Transmitters Mount to Microphones    100 Preset Selectable Channels    Receivers Runs on 12V Power/AA Batteries    Transmitters Run on Single AA Battery    1/4" Audio Output on Receivers

PLL Synthesized, 100 preset selectable frequencies with IR synchronization

Antenna diversity maximum range up to 262'

High-fidelity sound with no loss

LCD display shows the RF level, AF level, channel, and frequency

No need for bodypack transmitters. The transmitters mount onto AMT microphones

The receivers are powered by 12V power adapters or two AA batteries

1/4" audio output

Related Questions and Answers

Q: 1. Will this connect with a bluetooth head phone?

A: The Sabinetek AudioWow Mini-X Compact Wireless Bluetooth Microphone will not connect to a bluetooth headphone, but it will connect to a wired headphone.

Q: 2. Can I get the base plate?

A: The Really Right Stuff Base Plate for FUJIFILM X100V Digital Camera BH #REBX100VB • MFR #BX100V-B has been discontinued by the manufacturer.

Q: 3. Does it make sense to pair these with a 32bit-float recorder? or rather: do they transmit 32bits to the receiver so a zoom F6 would get the full dynamic range?

A: The 32bit aspect of the Zoom F6 allows for extremely high headroom while recording. This means that regardless of how high or low your audio signal being recorded is, the audio can be turned up or down after the fact to be usable. The type of audio being sent to the F6 does not impact the bit rate of the recorder. It would be a fine pairing in general.

Q: 4. Does this fit the x100iv?

A: Yes, the Really Right Stuff Hand Grip for FUJIFILM X100V Digital Camera will also fit the FUJIFILM X100VI Digital Camera. Please be aware that you need the Really Right Stuff Base Plate for FUJIFILM X100V Digital Camera in order to attach the hand grip. Unfortunately, the plate is no longer available.

Q: 5. Will the controller work with Zenmuse gimbals?

A: Due to the proprietary nature of competing systems, these two manufacturer's devices are incompatible.

Q: 6. Can I use any mic with this like a tram, sanken, DPA?

A: Yes, it is possible to use different microphones with the Comica Audio BoomX-U QUA Ultracompact 4-Person Wireless Microphone System for Mirrorless/DSLR Cameras as long as the microphone has the appropriate 3.5mm TRS locking connector and wiring, and does not require more voltage than the transmitter is able to supply. The Tram TR-50 and Sanken COS-11D Lavalier Microphones that are wired for compatibility with Sennheiser transmitters should both work, and certain DPA models may also work with the Comica transmitters, depending on their voltage requirements.

Q: 7. Can this movie controller be used to control FIZ via motor on a sony f55 fitted on a tripod

A: When using follow focus motors with the FREEFLY MōVI Controller yhe follow focus motors must be plugged into a Freefly gimbal for them to communicate with the Mōvi Controller.

Q: 8. Would it be possible to use two of these systems at the same time (a total of four TX and 2 RX)?

A: Yes, you can two of the Saramonic Blink 900 B2 2-Person Digital Camera-Mount Wireless Omni Lavalier Microphone Systems at the same time

Q: 9. are the batteries replaceable?

A: No, these have built in batteries.

Q: 10. will this work with the armorman 2 arms?

A: This is only listed as compatible with the Armor Man 3. We are not aware of it working with the older models.