Eliminate long DMX wiring cable runs for up to seven groups of light fixtures with the SWIT Electronics Pocket Wireless DMX Controller when the fixtures are connected by an optional wireless receiver. This portable DMX controller controls your fixtures wirelessly via 2.4 GHz or wired (requires optional USB to XLR cable). When using the wireless control with the optional receivers, it has a range of over 1300' line-of-sight, which saves you the headache of running all that cable.

The unit features eight sliders for controlling up to eight channels per light fixture. You can create up to seven groups of lights, for a total of 56-channels. The controller powers from two AA batteries, which will run it for approximately four hours, and you can also power the unit via a micro-USB port using the included cable and USB power supply. To save power the unit enters sleep mode after one minute of inactivity.

1 x Wireless DMX Controller/Transmitter    3 x Wireless DMX Receivers    DMX 512 Compatible    7 x Groups, 8 x Channels per Fixture    2.4 GHz, 1300' L.O.S. Range    8 x Discrete Sliders, Blackout Button

You can also use the controller in a wired DMX installation with an optional USB Type-A to 5-pin XLR adapter

Related Questions and Answers

Q: 1. What does Circuit protection mean for this battery?

A: Circuit Protection means that the battery has safety features to prevent spikes in power.

Q: 2. Is it flight safe?

A: When traveling on a flight the SWIT 140Wh Pocket Battery must be carried on and never checked in baggage. Each member of your crew that is traveling on the flight may carry up to two 100-159wh batteries with them. Please note that 160Wh or over cannot be brought on or air-shipped. The short answers are: All batteries MUST be carried on, NEVER checked in luggage. Up to 99Wh, each crew member may carry (8) eight plus one on each device ( camera, monitor, etc.) 100Wh-159Wh Each member may carry (2)two plus one on each device. 160Wh Cannot be brought on or air-shipped.

Q: 3. Is this compatible with the Sony FX6?

A: Yes, the Sony FX6 has a 2.5 mm sub-mini control port and the LanParte LANC Wireless Controller Kit interfaces with any camera with a 2.5mm LANC remote connection.

Q: 4. This system came up when I filtered for "uncompressed" wireless systems. Is it truly uncompressed? Is there any quality loss?

A: The SWIT CURVE500 HDMI Wireless Video Transmission System is compressed. This model uses H264 compression. Please see below for SWIT's uncompressed wireless solution. SWIT FLOW500 SDI & HDMI Wireless Video & Audio Transmission System BH #SWFLOW500

Q: 5. Can I trigger 2 receivers with one remote?

A: The Lanparte LANC Wireless Controller Kit is intended to be used with only 1 transmitter and 1 receiver per set.

Q: 6. Is this compatible with the Panasonic HC-X2?

A: Yes, according to LanParte the LanParte LANC Wireless Controller Kit is compatible with the Panasonic HC-X2.

Q: 7. Will this trigger record start/stop on a Atomos NINJA V?

A: The LanParte LANC Wireless Controller Kit (BH #LALANC02) is designed specifically for Sony, Panasonic, and Blackmagic cameras, and likely wouldn't work with the Atomos Ninja V. For the Ninja, we recommend the Libec Rec/Stop Remote Control for Atomos Recorders/LANC Equipment (BH #LIRECLA). Libec Rec/Stop Remote Control for Atomos Recorders/LANC Equipment BH #LIRECLA

Q: 8. What type of batterys does it use?

A: Using the 2.5mm LANC cable to connect the receiver to the camera body, the receiver can draw power from the camera directly. The transmitter uses a replaceable button cell.

Q: 9. Are the USB Type A and C outputs Male or female?

A: The USB outputs on the SWIT 140Wh Pocket Battery with D-Tap and USB Outputs (V-Mount) are all female.

Q: 10. Is this just the LANC-01 with an added wireless remote?

A: No it is not.