The fail-safe, maintenance-free Tru-Dot Tritium Night Front Sight from Meprolight does not require an external power source, and provides years of green illumination in all weather and light conditions. It replaces the stock front iron sight on Springfield XDM and XDS handguns without the need for any permanent modification or gunsmithing, and offers a single green dot to clearly mark your aiming point. Made from lightweight and durable aluminum with a chip, scratch, and corrosion-resistant anodized finish these sights are designed to stand up to years of recoil.

Replaces Stock Front Sight    Battery-Free Green Tritium Illumination    Springfield XDM & XDS    Anodized Aluminum

Related Questions and Answers

Q: 1. Is it possible to attach it to the IWI Masada Pistol??

A: Yes, it comes with the mount to do it.

Q: 2. Will this work with the Hi-Point 9mm carbine?

A: Yes I have switched this optic between several AR/s and now have it on a keltec sub2000 gen 2 glock17 with a flip mount holds true for 50 meters after about 500 rounds down range

Q: 3. Do these sights have the same point-of-aim as the original factory sights?

A: Yes, they are dead accurate! Just yesterday I shot at a man sized target and hit it 10 out of 10 times at a 100 yds. Note: I am an old Marine and shoot very well.

Q: 4. what battery goes in the scope?

A: The Barska 30mm Red Dot Sight comes with a CR2032 Lithium Battery.

Q: 5. What is the height from the rail to the bottom of the screen? Will this work with Magpul mbus pro front and rear sights?

A: The only physical dimensions EOTech list are: Dimensions L: 3.8 x W: 2.9 x H: 2.3" / L: 9.7 x W: 7.4 x H: 5.8 cm Weight 11.2 oz / 317.5 g

Q: 6. Will this fit a Sig Sauer P365 XMacro?

A: Unfortunately no, they do not make one for the P355 XMacro.

Q: 7. will this fit Springfield XD-45 ?

A: To mount the Trijicon RMRcc Red Dot Sight (3.25 MOA Dot) to a Springfield XD-45, your will need the AC32097 mount if the pistol is not the optics ready model. If the pistol is the optics ready model, then unfortunately there is no RMRcc mounting plate available, and I would recommend using the RM06-C-700672 RMR Type 2 .

Q: 8. which is front and which is back ?

A: Front is the eye brow end

Q: 9. WILL THIS SIGHT WORK ON A CROSSMAN 2240?

A: Im not familiar with Crossman 2240. It would be best to contactCrossman Service Dept for advise.

Q: 10. When were these sights made? After Eotech made the point of shift corrections or before?

A: All of our EOTech sights have been made post change. There have not been any of those sights around for 2 years.