Made of injection-molded ultra-high-strength polypropylene copolymer resin, this large SKB Cases iSeries Waterproof Lure Case is made to withstand the most extreme and demanding shipping, handling, and fishing conditions on the planet. The 13 x 9.5 x 6.5" interior has 48 adjustable and removable compartments to customize your lures and other supplies.

Design features include gasket sealing that makes the case dust and waterproof, a molded-in hinge for added strength, dual stainless steel reinforced padlock holes, and a trigger release latch system. The case is further resistant to a variety of hazards that you may encounter such as impacts, ultraviolet (UV) radiation, solvents, corrosion, and even fungi. A pressure relief valve comes into play especially during air transport by regulating the internal pressure, keeping your gear and the case from getting crushed and allowing you to open the case without having to break a tough pressurized seal that may develop.

This case is made in the USA and as with all of their ATA-rated hard cases, SKB will cover up to $1500 to repair or replace equipment damaged by a commercial airline carrier while secured in the case, no registration required.

Airtight and Waterproof to Mil Specs    48 Adjustable Compartments for Lures    Interior Corrosion Inhibitor    Polypropylene Copolymer Resin    UV/Solvent/Corrosion/Fungus Resistant    Trigger Release Latch System    Pressure Relief Valve    Molded-In Hinge and Padlock Holes    $1500 Content Coverage    Made in the USA

Related Questions and Answers

Q: 1. This case looks very spacious in a good way. Is it future proof for newer phone models and the slight varying sizes they come in?

A: The JOBY SeaPal Waterproof Case for Smartphone is made to work with, iPhone 15, 14, 13 (Not Mini), 12 and the Samsung Galaxy S23, S22 models. It might not fit future models.

Q: 2. Will this fit the Pentax K-1 with 50mm macro lense?

A: Yes, the K-1 with the 50mm macro lens will fit into this housing however there is going to be excess room.

Q: 3. Does this work with a Nikon D3200 (without using the flash)?

A: The waterproof case works with most DSLR cameras. Both my Nikon D610 and D5000 fit inside, as well as a 24-70 mm and an 18-55 mm lens. A smaller DSLR will move around inside the case a little, and I had to use some weights tied to the bag to keep it submerged underwater while shooting. Overall, it got the job done. As for shooting without flash, that might be more of a challenge underwater. I was using off-camera flash while shooting (Nikon SB-700 Speedlight).

Q: 4. will this fit fuji xt5?

A: Yes, the DiCAPac WP-S10 Waterproof Case can work with a Fujifilm X-T5.

Q: 5. Will my Nikon D7000 with 18-105mm lens fit in?

A: DiCAPac recommends the WP-S5 for the D7000. You could use the Nikon 18-105mm lens but the zoom range might be limited.

Q: 6. Does this fit the canon 5D mark iii?

A: Yes it will! I've used it with a mark iii with a 24-105 no problem. Also used a GH4 and a 6D

Q: 7. Will it fit canon 77d with battery grip ?

A: It has about 1 on either side of a Canon 7D and 5D. I am returning mine since the finger holes are placed so the telephoto tens can't be adjusted.

Q: 8. will this fit my canon 70-200mm f2.8 ?

A: It will not. Unfortunately, we do not have any waterproof cases from DiCAPac that support the 70-200 f/2.8.

Q: 9. looking for dust protection at Burning Man Festival. will this do it?

A: Short answer is no. The main part is okay but the attachment of the plastic fingers broke on my second use. If you use it I would tape up the finger holes with duct tape. DEFINITELY do not use for underwater with an expensive camera. Mine was destroyed in the process. The warrantee phone number does not work in Canada. B&H refused to deal with the issue. As a result I have not bought B&H since.

Q: 10. Would the Gh4 work with this?

A: Yes, you can use the Panasonic GH4 with the WP-S10.