The Avenger F100 Junior Offset Arm, in chrome-plated steel, allows you to place a light over an obstruction, such as a wall, or offset a large light fixture from its stand. The F100 mounts to a stand with a 1-1/8" Junior receiver, and will accept a light fixture with a Junior 1-1/8" pin.

Chrome-Plated Steel Construction    1-1/8" Pin and Receiver

Related Questions and Answers

Q: 1. Can I load a Mola Mantti 43.5 with a profoto D1 / B1 head? thats like 27-28lbs at what length max can I place the Mola it says it only holds 22Lbs at max so at what length can I place 28lbs?

A: I have used the arm to its maximum load, but the boom clamp is inadequate to hold the load at maximum extension. I ended up using a locking block and tackle run from the counterweight to the stand to keep the arm raised into position and to facilitate the smooth lowering of it. I also had to weight the stand accordingly as you'd expect. Cheers, Bill.

Q: 2. Would a para 133 and siros (15lbs) twist around or would the modifier stay at the angle I put since it would be front heavy?

A: Once you lock everything down it should not twist or rotate.

Q: 3. What are dimensions of the base?

A: 5.9 x 3.6 inches

Q: 4. Extension arm that can hold my camera

A: If you must you can use , Manfrotto 155 Double Ball Joint Head with Camera Platform B&H # MA155 , depending what camera you are using

Q: 5. what is the best light stand?

A: This boom is made for mounting to Junior stands. A C-stand does not have the correct receiver, width of base and stability, or weight capacity to safely support it at its maximum load and extensions.

Q: 6. Can you use the Avenger D650 Junior Boom Arm with the Avenger A2018F C-Stand?

A: Hi! I use this boom arm on an assortment of stands. The way it attaches is actually clamping on, not mounting to the top. So, as long as the stand you're using can support the weight, you should be good to go. It is a very heavy boom arm, but incredibly sturdy. Hope that helps.

Q: 7. Where can I get a Handle for the counterweight? The bolt sucks

A: A handle is not sold separately . It is a part sold by Manfrotto . You can reach them at 480-940-1103

Q: 8. What is the weight capacity?

A: Matthews does not specify a weight load limit. You will need to consider the load strength of your light stand and if it can handle the off axis weight of the arm.

Q: 9. is the attached grip stationary and will this grip attach to a Manfrotto light stand for an overhead rig?

A: The grip head is fixed. In some cases and with other accessories you can use this for a overhead rig. You will want to make sure the particular stand has the load capacity for it.

Q: 10. What is the length of this arm?

A: The Length of the D650 Junior Boom is 63.6 to 117.6' / 1.6 to 2.98 m